Dancover Crestline 2L User manual

Camping tent
Crestline 2L
28-06-2013

Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m2. It
is your responsibility to comply with local rules and regulations and to ensure that
the marquee/tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the
marquee/tent is safely secured and that the marquee/tent does not cause damage
to others.
close to the tent.
The marquee/tent must be safely secured. We recommend you secure your
marquee/tent with straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow always remove snow from the roof of the marquee/tent
regularly to prevent snow from building on the roof as heavy snow can cause the
marquee/tent to collapse.
In the event of rain there is a risk of rain puddles building up on top of the roof of the
marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsi-
bility to ensure rain puddles do not build up. As a precaution, make sure theroof of
the marquee/tent is stretched out properly and adequately over the side frames of
the marquee/tent and remove rain water regularly.
Please always check our website for the latest safety advice and manuall.
Note: Marquees are intended for events and other arrangements and are as such only
meant for short term temporary assembly and the following disassembly. Dancover
warranty applies only to the normal use of the Product, normal wear and tear excepted,
in accordance with written use instructions or manual. The warranty does not apply to

Revised 5/1/6
Crestline 2
1. Lay out the ‘inner’ tent flat on the ground, so that you are able to see the pole
sleeves. The poles are black. Insert into the relevant pole sleeves.
2. Assemble the poles and lay to one side.
3. Insert the poles into the correct pole sleeves to form the dome.
4. Position and secure.
5. Drape the flysheet over the dome and tie the ribbons to the poles (top and sides).
6. Insert the porch poles
7. Guy the tent.
8. Peg the tent into position.
Coleman tent - tips
Condensation:- Try not to leave damp items inside the tent. Make sure you make
use of the ventilation flaps at the bottom of the tent, also those at high level.
Tension:- Check if zips run smoothly, if not try releasing some tension from the end
guy ropes.
Cleaning:- Dirt can be removed by brushing softly or rubbing with a soft soap
solution. Detergents cannot be used as these can effect the water-repellent effect of
the fabric. Rinse all traces of soap well and dry off the tent.
Packing/Storage:- Remove all poles. Lay the tent flat on the ground and fold in half
making sure no air is trapped inside the tent.
If you remove the air it will make the tent easier to be inserted into the carry bag.
Fold flysheet in half in the opposite direction. Fold in half again until the width and
length are the same as the carry bag. Ensure that the poles are kept separate from
the tent. This should now fit into the carry bag.
If the tent is transported ‘’wet’’ from the campsite, spread the tent out when you get
home and allow it to dry before storing.

Contact information
Head office:
Dancover A/S
Nordre Strandvej 119 G
3150 Hellebæk
Denmark
For more information
please visit:
www.dancovershop.com
National contact
Denmark:
[e-mail]
UK:
[e-mail]
Spain:
[e-mail]
Italy:
[e-mail]
Germany:
[e-mail]
Switzerland:
[e-mail]
France:
[e-mail]
Austria:
[e-mail]
Sweden:
[e-mail]
Finland:
[e-mail]
Nederland:
[e-mail]
Poland:
[e-mail]
Ireland:
[e-mail]
Luxembourg:
[e-mail]
Belgium:
[e-mail]
Norway:
[e-mail]