Dancover CombiTent PARTY TENT SEMI PRO User manual

18-06-2021
7x12m - Side height 2,3m
PARTY TENT SEMI PRO, CombiTent

Safety Advice
Attention
In some countries approval is needed to set up a marquee/tent larger than 75 m . It is your responsibility to comply with local rules and
regulations and to ensure that the marquee/tent is assembled correctly.
In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is safely secured and that the marquee/tent does not cause
damage to others.
The marquee/tent must be safely secured. We recommend you secure your marquee/tent with straps and pegs as soon as it is assembled.
Make sure to check if the marquee/tent is covered by your home contents insurance.
Marquees/tents must be evacuated under extreme weather conditions.
In the event of snow, always remove snow from the roof of the marquee/tent regularly to prevent snow from building on the roof, as heavy snow
can cause the marquee/tent to collapse.
In the event of rain, there is a risk of rain puddles building up on top of the roof of the marquee/ tent. Heavy rain puddles can cause the roof to
collapse. It is your responsibility to ensure rain puddles do not build up. As a precaution, make sure the roof of the marquee/tent is stretched out
properly and adequately over the side frames of the marquee/tent and remove rain water regularly.
Do not unpack or repack your marquee/tent in freezing temperatures. In case of temperatures below zero, always unpack and repack your
marquee/tent indoors to avoid the risk of cracking parts.
The marquee/tent must be totally dry before you repack and store it to avoid mildew.
Note: Marquees are intended for events and other arrangements and are as such only meant for short term temporary assembly and the
following disassembly. Dancover warranty applies only to the normal use of the Product, normal wear and tear excepted, in accordance with
written use instructions or manual. The warranty does not apply to damage caused by accident, abuse, misuse, or modication of the Product.
Warranty Information
Please visit dancovershop.com for information on warranty.
Please always check our website for the latest safety advice and manual.

Warning
1
The pipes are covered in oil. Before you set up your tent please remove the oil carefully to keep the cover clean.
2
Take note that the tent needs to be handle with care to avoid damages.
3
Do not force the frame as they may be damage in the process.
4
Tents are meant as temporary shelters and must be evacuated under extreme weather conditions.
Please select a suitable site for the tent to avoid damage to underground sprinkler systems, water, gas or electrical lines.

18-06-2021
7x12 -2,3 PARTY TENT SEMI PRO, CombiTent

CombiTent roof explanied
4m section with
gable 4m section without
gable
2m section without
gable
2m section with
gable
2m section without
gable
7x14
4m section with
gable 2m section without
gable 2m section with
gable
7x8
4m section with
gable 2m section with
gable
7x6
4m section with
gable 4m section without
gable
2m section without
gable
2m section with
gable
7x12
4m section with
gable 4m section without
gable
2m section with
gable
7x10
1st. Velcro Roofcover
Roofcover
2nd Velcro
Use the velcro overlay to attach 2 roof sections to each other.
2nd. Velcro Roofcover
Roofcover
1st. Velcro
When you are making your CombiTent shorter. Use
the velcro overlay to detach roof sections.
7x12 -2,3 PARTY TENT SEMI PRO, CombiTent

7x12 -2,3 PARTY TENT SEMI PRO, CombiTent
I
Select a flat ground for the tent, unpack the carton and check that all the parts including tubes, tent and accessories… etc. are present same as on the part list.
Assemble the framework of rooftop by joining the parts (7, 8, 9-1,9-2, 10-1, 10-2, 11, 12) together with poles (2.3).To ensure the screw fixed to every pole tightly

7x12 -2,3 PARTY TENT SEMI PRO, CombiTent
II
Attach one end of supported pole (4.5) to the joints(8,11),Strengthen the frame by using screws and turnbuckle set (17). Long screws are used on all connection
between 50mm and 54mm pipe. Short screws are used on connection between 42mm and 38mm pipes.

7x12 -2,3 PARTY TENT SEMI PRO, CombiTent
III
Cover the roof on the frame and attach it with the bungee balls. Take care of the
tension of the bungee balls, if you use too many on one side of the tent, it may be
too tight to tie the other side. Leg 1 with holes, should be on both sides of the
tent.
IV
Attach all supported poles (1) to the joints (7.10), built-up the framework use
the super pegs to fix the poles into the ground. Tighten the frame with the
turnbuckle set (18).

7x12 - 2,3 PARTY TENT SEMI PRO, CombiTent

e
Head office: