Danfoss NovoCon S Digital User manual

1
Heating Solutions VI.HU.G3.02 SMT/SI
❷ ❸ ❹
❺
❼
①
②❻
①
③
Calibration:
Press button ①until two
LED’s are turned on
DIP switch: ②
Manual override:
Adjust wheel ③
②
Serial number can be removed
from the NovoCon®S and
added to installation drawing.
Device Object
Instance Number
H100 VXX
15 04 12
0030471
H100 VXX
15 04 12
0030471
MADE IN SWEDEN
NovoConTM S Hybrid
003Z8500
Actuator for AB-QM DN10-32
Control signal: 0-10V/0-20mA/BACnet MS/TP
Power: 24VAC/DC, 50/60 HZ
Force: 90N, Stroke: 7 mm, Speed: 3-24s/mm
Consumption: 3,25VA running, Standby 0,8W
IP54/40, -10T55
III
H100 VXX
15 04 12
0030471
H100 VXX
15 04 12
0030471
MADE IN SWEDEN
NovoConTM S Hybrid
003Z8500
Actuator for AB-QM DN10-32
Control signal: 0-10V/0-20mA/BACnet MS/TP
Power: 24VAC/DC, 50/60 HZ
Force: 90N, Stroke: 7 mm, Speed: 3-24s/mm
Consumption: 3,25VA running, Standby 0,8W
IP54/40, -10T55
III
01
01
01
®
Installation Guide
NovoCon® S Digital/Hybrid High Accuracy Actuators
❶
IP40
IP54
IP54
IP54
VIHUG302

VI.HU.G3.02 / 003Z8047
❾ ❿
⓫
DIP Switch
12345678910
ON
OFF
DIP Switches 1 to 7 are used to assign the MAC address
manually. Default setting is Auto MAC addressing. For
termination of last unit on the BACnet bus, turn DIP
Switch 8 ON.
Dip switches 9 and 10 are not used.
Safety Note Safety Note
Disposal instruction
Always follow the local disposal regulations.
To avoid injury and damage to persons and
devices, it is absolutely necessary these
instructions are carefully read and observed
prior to assembly and commissioning.
Necessary assembly, start-up, and maintenance work must
be performed only by qualied, trained and authorised
personnel.
Switch o the power line before wiring the actuator.
Connect via safety isolating transformer.
Galvanic separations shall be provided for
segments crossing buildings.
Red
Black
Green
White/
green
Power
Common ground for power and bus signal wire
´+´ non-inverting signal wire
´−´ inverting signal wire
NovoCon®digital cable
Red
Black
Grey
Blue
Power
Power ground
Analog input
Analog input ground
NovoCon®analog cable
❽
Digital port
Analog port or
voltage booster
Digital port
BACnet presettings
NovoCon®S
Hybrid
BV:0
Analog (default)
or
Digital Control

NovoCon®S
Digital
MSV:3
Select Valve Type
(default AB-QM
DN 15)
AV:0
Design Flow Rate



Common ground shall be
used for all devices on the
same network.
Installation Guide NovoCon®S Digital/Hybrid High Accuracy Actuators
Produced by Danfoss A/S © 05/2015