De La Espada NERI&HU User manual

0
1
N
E
R
I
&
H
U
PARTS
1x Headboard
1x Footboard
2x Sidebeams
2x Crossbeams
16x Timber slats (NOTE: California King size has 17x Timber slats plus
2x additional M5x40 bolts and washers)
HARDWARE
(16x) M8x30 bolts (8x) M8x35 bolts
(32x) M5x40 bolts (32x) M5 washers
YOU WILL NEED
-5mm socket/ratchet set OR cordless drill with the appropriate
attachment
-5mm Allen Key
-The help of a friend
NOTES
NOTE 1: Be certain that all assembly is carried out on a at
and stable surface. This will ensure a good nal result.
Reverse the steps to disassemble the piece.
NOTE 2: Your furniture arrives packed in numerous layers that
protect it during transport. It is important that you remove
the packaging carefully to avoid damaging your furniture. Refer
to our information sheet “Unpacking Your Furniture” for further
details.
NOTE 3: Great care is required when assembling our products .
Use blankets to soften the assembly surface - hard surfaces
such as wood or stone ooring may damage the furniture if in
direct contact.
NOTE 4: We advise that assembly and disassembly of De La Espada
furniture is undertaken by a minimum of 2 people.
NOTE 5: When screwing in bolts, tighten well, but be sure
NOT TO OVERTIGHTEN. This can cause the thread to strip thus
resulting in a poor connection.
NOTE 6: All mating parts are numbered so they correspond to
the appropriate part around the frame of the bed. you will
ensure the best possible t if all parts are mated with the
corresponding numbered parts. While you work, be sure all
connections are ush with no gaps.
ASSEMBLY INSTRUCTIONS
FRAME BED WITH ARMS BY NERI&HU
[e-mail] M
DELAESPADA.COM

0
2
N
E
R
I
&
H
U
ASSEMBLY INSTRUCTIONS CONTINUED
FRAME BED WITH ARMS
1. ATTACH SIDEBEAMS TO HEADBOARD AND FOOTBOARD
a) Unpack components and set them out so they are in the cor-
rect orientation. Check for number markings.
b) Connect the sidebeams to the headboard and footboard by in-
serting the 16x M8x30 bolts and tightening with an Allen Key.
[e-mail] M DELAESPADA.COM
INSTRUCTIONS
2. ATTACH CROSSBEAMS
a) Place crossbeams in position, following number markings
b) Insert the 8x M8x35 bolts and tighten with an Allen Key.

0
3
N
E
R
I
&
H
U
3. ATTACH THE TIMBER SLATS TO THE PLATFORM BASE
a) Space out the bed slats so they are aligned with the
corresponding holes on the timber lip on the inner face of
the side beams. The underside of the each slat has a threaded
sleeve xed inside. If the sleeve drops out, there are spares
you can use. The top of each slat has a recess for the washer.
b) Place a washer in the recess of each slat and insert an
M5x40 bolt through the slat and into the sidebeam. Using a
cordless drill or socket set, tighten the bolts. Tighten the
slats well, so they are not wobbly, but be very careful not to
overtighten.
ASSEMBLY INSTRUCTIONS CONTINUED
FRAME BED WITH ARMS
[e-mail] M DELAESPADA.COM
c) Assembly is now complete and bed is ready to receive a
mattress.