DeLonghi KH390715CM User manual

www.delonghi.com 5710810901_00_0517 Printed in China

KH390715CM
OIL FILLED RADIATOR
Instructions for use. Keep these instructions
Visit www.delonghi.com for a list of service centers near you.
ELECTRIC CHARACTERISTICS
120 V~ 60 Hz1500 W
RADIADORES ELÉCTRICOS DE
ACEITE
Repase y guarde estas instrucciones.
Lea cuidadosamente este instructivo antes de usar su aparato.
Visite www.delonghi.com para ver la lista de centros de servicios
cercanos a usted.
CARACTERISTICAS ELECTRICAS:
120 V~ 60 Hz1500 W

2
EN ES
page 4 pág. 7

3
A
B
C
D
E
1

4
IMPORTANT
SAFEGUARDS
When using any electrical appliance, some basic safety
precautions should always be observed to reduce the risk
of re, electric shock, and/or injury to persons. Read all in-
structions carefully before using the appliance. Specically:
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- Do not operate any heater with a damaged
cord or plug or after the heater malfun-
ctions, has been dropped or damaged in any
manner.
If heater has leaked any oil, discontinue
using the heater and contact the service
centre as indicated in the instruction leaet.
Return heater to authorized service facility
for examination, electrical or mechanical
adjustment, or repair.
- This heater is not intended for use in bathro-
oms, laundry areas, or similar indoor loca-
tions. Never position the appliance where it
may fall into a bathtub or come in contact
with water.
- Use this appliance only as described in this
manual. Any other use not indicated by the
manufacturer may cause re, electric shock,
or injury to persons.
- CAUTION: To prevent electric shock, make
sure the wide prong of the plug is inserted
in the wide slot of the outlet.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
- The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or instruc-
tion concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
- Extreme caution is necessary when any hea-
ter is used by or near children or invalids and
whenever the heater is left operating and
unattended.
- Do not wrap the cord around the appliance
immediately after use.
- To prevent current overload and blown fu-
ses, make sure that no other appliance is
plugged into the same outlet or into another
outlet wired into the same circuit.
- If the power cord is damaged, to reduce the
risk of malfunction it must be replaced by
the manufacturer, its service agent, or a li-
censed and qualied professional.
- Do not use this appliance with an extension
cord or outlet strip. Connect the appliance
directly to a suitable outlet.
Danger of burns!!
Failure to observe the warning could result in burns or
scalds.
- This appliance gets very hot when in use.
To prevent burns, do not touch hot surfaces
with bare skin. Use the handle when moving
the appliance. Keep all ammable materials,
such as furniture, pillows, bedding, paper,
clothing, and curtains at least 3 feet (90 cm)
from the front and top of the appliance, also
avoid contact with the sides and back.
- Do not run the power cord under carpeting.
Do not cover cord with throw rugs, runners,
or the like. Keep the cord away from any pas-
sageways where it could be tripped over.
- Do not insert or allow foreign objects to get
into the air intake or air outlet grille, as this
may cause electric shock or re, or damage
the appliance.
- To prevent a possible re, do not block air in-
take or air outlet grille in any way. Do not use
the appliance on soft surfaces, such as beds,
where the openings may become blocked.
- Do not cover the appliance while it is fun-
ctioning in order to avoid overheating and
the risk of re.

5
- The internal parts of the appliance can beco-
me very hot or produce sparks during opera-
tion. Do not use the appliance in areas where
gasoline, paints, or other ammable liquids
are used or stored.
- It is normal for heater’s plug and cord to
feel warm to the touch. However, an exces-
sively hot or deformed plug or cord is not
normal and may be the result of a defective
electrical outlet. Defective outlets must be
replaced before using the heater. Plugging
the heater into a worn outlet may result in
overheating of the power cord or may cause
the risk of re.
- Do not place the heater near a bed because
objects such as pillows or blankets can fall
o the bed and be ignited by the heater.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your radiator is equipped with a
polyethylene tape used as a carry handle,
remove it before connecting appliance to
the outlet.
- Always disconnect the plug from the power
outlet when the appliance is not in use.
- Do not use the appliance outdoors.
- To completely turn o the appliance, push
the ON/OFF button, and then unplug the
heater.
- Connect to properly polarized outlets only.
- Make sure that the plug is fully inserted into
the outlet.Wall outlets may deteriorate with
time, so check the plug periodically for signs
of overheating or deformation. If the outlet
has deteriorated, stop using it and have it
repaired.
- Check that neither the appliance nor the po-
wer cord have been damaged during ship-
ping.
- Make sure that no styrofoam or other pa-
cking materials remain in the appliance.
- Make sure that no pieces of polystyrene or
other packaging material have been left
between one element of the appliance and
another. It may be necessary to pass over the
appliance with a vacuum cleaner.
- The rst time the appliance is used, run it at
the maximum power for at least two hours.
During this time, ventilate the room thorou-
ghly to eliminate the “new” smell released
by the appliance. It is completely normal for
the appliance to emit “creaking” sounds the
rst time it is run.
- Extreme caution is necessary whenever the
heater is left operating unattended.
- Do not open the appliance. No user-service-
able parts inside.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
(see figure on pag. 3).
A Thermostat
B Switches
C Comfortemp button
D Cord holder
E Wheel
USE
Electrical connection
- Before plugging the radiator into the outlet, check
that the voltage of your outlet electricity supply cor-
responds to the value V indicated on the appliance
and that the socket and power line are appropriately
dimensioned.
- This appliance complies with directive on electromag-
netic compatibility.
Models with “Easy wheel” sytem
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the castors by turning them outwards (Fig.1).
Turn the radiator back to its upright position.
Important!
When in use, the radiator should always be kept vertical

6
(wheels at the bottom, controls at the top). Any other po-
sition could be dangerous!
INSTRUCTIONS FOR USE
Switching on
Turn the thermostat dial clockwise to maximum.
Turn on both switches. The lights on the switches remain on
irrespective of the cycle set by the thermostat.
When the room reaches the required temperature, turn the
dial counter clockwise slowly until you hear a click.
The appliance will come on and go o automatically to main-
tain the required temperature.
Economiser
For economy of use, the switches can be used singly:
- button in position «MIN» only = minimum power (light
on)
- button in position «MED» only = medium power (light
on)
- buttons in both positions «MIN» and «MED» = maxi-
mum power (lights on)
Using the thermostat
The thermostat operates on the basis of room temperature
and not radiator temperature.
Turn the thermostat dial counter clockwise towards the
lower numbers to reduce the temperature; turn it clockwise
towards the higher numbers to raise the temperature. To
turn the appliance o completely, turn the thermostat to
minimum and unplug from the outlet.
Frost protection function
With the thermostat in position and the switches
pressed, the appliance maintains the room at a temperature
of about 41°F (5°C) , preventing freezing with minimum en-
ergy consumption.
COMFORTEMP BUTTON
With the“COMFORTEMP”button and both switches pressed,
the appliance is automatically set to reach and maintain
what is considered to be the comfort temperature.
A green light comes on to indicate activation of “COMFOR-
TEMP”. In this mode the temperature is automatically set
only by the “COMFORTEMP”. To deactivate this mode and
return to thermostat operation, press the COMFORTEMP
button again.
MAINTENANCE
Before carrying out any operation on the radiator, unplug
from the electric outlet and wait for it to cool.
The oil-lled electric radiator requires no particular main-
tenance. It is sucient to remove the dust with a soft, dry
cloth. Never use abrasive powders or solvents. If necessary
remove concentrations of dirt using a vacuum cleaner.
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work Be sure it is plugged in and that the elec-
trical outlet is working.
Check for any obstruction.
The temperature may be set too low.
Plug into the power outlet.
Remove the obstruction and let the appliance
cool down. If the appliance doesn't work please
contact the De longhi toll free number.
Set the temperature to a higher position.