DeLonghi TRD40615ECA User manual

9
IMPORTANT
SAFEGUARDS
When using any electrical appliance, some basic safety
precautions should always be observed to reduce the risk
of re, electric shock, and/or injury to persons. Read all in-
structions carefully before using the appliance. Specically:
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
- The appliance must not be placed
immediately under a xed power
socket.
- Do not use the appliance outdoors.
- This heater is not intended for use in
bathrooms, laundry areas, or similar
indoor locations. Never position the
appliance where it may fall into a
bathtub or come in contact with water.
- If the power cable is damaged, stop
using the product. Power cable must
be replaced by the manufacturer, an
authorised service centre or a qualied
electrician in order to eliminate all risk.
- Do not use this heater in the immedi-
ate surroundings of a bath, a shower or
a swimming pool.
- Do not insert or allow foreign objects
to enter any ventilation or exhaust
opening as this may cause an electric
shock, re, or damage the heater.
Important!
Failure to observe the warning could result in injury or dam-
age to the appliance.
- The appliance is not intended for use
by persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to
ensure that they do not play with the
appliance.
- CAUTION — Some parts of this
product can become very hot and
cause burns. Particular attention
has to be given where children
and vulnerable people are pres-
ent.
- The internal parts of the appliance can
become very hot or produce sparks
during operation. Do not use the
appliance in areas where gasoline,
paints, or other ammable liquids are
used or stored.
- This heater is lled with a precise
quantityofspecialoil.Repairsrequiring
opening of the oil container are only to
be made by the manufacturer or his
service agent who should be contacted
if there is an oil leak; when scrapping
the heater, follow the regulations
concerning the disposal of oil.
- ATTENTION: To avoid the safety
system resetting accidentally, this
appliance must not be powered
through an external on/o device such
as a timer, or connected to a circuit
which is turned o and on regularly by
the energy supplier.
- Do not use the appliance in small
rooms when they are occupied by
persons that are not capable of leaving
the room, unless constant supervision
is provided.
- Always disconnect the plug from the
power outlet when the appliance is
not in use.
- Do not wrap the cord around the appli-
ance immediately after use.

10
- When the appliance is in use unwrap
the cord from the cord holder.
-The appliance must not be located im-
mediately below a xed socket-outlet.
Danger of burns!!
Failure to observe the warning could result in burns or scalds.
- WARNING: To avoid
overheating, never under
any circumstances cover the
appliance during operation as this
would lead to a dangerous rise in
temperature, and risk of re.
Do not use the appliance on soft
surfaces, such as beds, where the
openings may become blocked.
- Do not run the power cord under car-
peting. Do not cover cord with throw
rugs, runners, or the like. Keep the cord
away from any passageways where it
could be tripped over.
Please note:
This symbol indicates recommendations and important infor-
mation for the user.
- Always use the appliance in an upright
position.
- Do not use this appliance with an
extension cord or outlet strip. Connect
the appliance directly to a suitable
outlet.
- Make sure that the plug is fully
inserted into the outlet. Wall outlets
may deteriorate with time, so check
the plug periodically for signs of
overheating or deformation. If the
outlet has deteriorated, stop using it
and have it repaired.
- To prevent burns, do not touch hot
surfaces with bare skin. Use the
handle when moving the appliance.
Keep all ammable materials, such
as furniture, pillows, bedding, paper,
clothing, and curtains at least 90 cm
(3 feet) from the front and top of the
appliance also avoid contact with the
sides and back.
- Do not use the appliance in rooms with
a oor area of less than 4m².
- Before putting the appliance away,
make sure it is completely o and
unplugged from the mains socket.
Wrap the cable around the base.
Do not store in dusty atmospheres.
- Do not rest anything on the appliance.
- Donotusetheappliancetodrylaundry.
Do not obstruct the air intake and
outlet grilles (danger of overheating).
- Do not use the appliance near walls,
furniture, curtains, etc.
- Do not place the heater near a bed
because objects such as pillows or
blankets can fall o the bed and be
ignited by the heater.
- Never place the power cable on top of
the heater while it is hot.
- We recommend that you not place the
heater in a draught, because strong
draughts of air may adversely aect
the equipment’s operational ecien-
cy.
- The rst time you use the appliance,
operate it of at least 2 hours with the
thermostat at maximum to eliminate
the“new”smell.
A little smoke due to the protective
substances applied to the heating el-
ement before transport may be given
o.
- Position the appliance so that the plug
and the outlet can be easily reached
even after installation.
- The appliance is tted with a safety

11
device which will switch o it in case
of accidental overheating. To reset,
please contact Customer Experience,
see enclosed guarantee.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A Display
B On-o button
C Power setting button
D + Adjustment button
E - Adjustment button
F Timer button
G Brightness button
H Eco button
I Cord holder
L Wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint nish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface
area of less than 43 square feet (4 sq.m.).
Power connection
The radiator must be connected to a properly polarized A/C
110/120V household outlet in perfect working condition.
The appliance will be set in the o condition.
The display will show the symbol. Keep loose clothing
or bedding, furniture and ammable material away from
the power outlet where the heater is plugged in.
After an interruption of the power supply (power failure or
appliance unplugged) the unit goes always to o.
When the unit is switched on by pressing the on-o button,
the operating conditions will be same ones previously set.
Heating function
To turn the appliance on, press the (B) button.
Press button (C) to set the required power level:
MIN ( ); MED ( ); MAX ( ).
To select the desired temperature, press button + or - (E
or D). By pushing the + or - button once, the temperature
(shown on the display) will increase or decrease by 34°F
(1°C) . Holding the + or - button depressed the value will
increase o decrease rapidly.
The appliance allows to set a temperature of 5°C (41°F) and
a range from 10°C to 28°C (50°F to 82°F).
Anti-freeze function
Setting the temperature to 5°C (41°F), the appliance
will activate the Antifreeze function. The display will
show the symbol, in this way the appliance will turn
on automatically, at the max power, only if the room
temperature falls below 5°C (41°F), to prevent freezing
conditions. If you wish to go back to the Heating function,
press the "+" button once.
Please note: in this function the power level settings
are not able to be adjusted, unit will run at MAX.
Eco function
When this function is active the appliance automatically
sets the most appropriate power level to guarantee
optimum comfort while reducing energy consumption.
Your product is equipped with a polarized alternating
current line plug (a plug having one prong wider than the
others). This plug will t into the power outlet only one
way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug. If the plug
should still fail to t, contact your electrician to replace
your obsolete outlet. Do not attempt to modify the plug to
bypass this safety feature.
Fig. 1

12
To activate this function press the "ECO" (H) button. The
display will show symbol.
If the selected temperature is much higher then the actual
room temperature, the appliance will start automatically
and rapidly to heat the room.
Theappliancewill automatically selectthe most convenient
power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
button, the appliance will cycle between: MAX-MED-MIN-
OFF. If MED power level has been selected, the appliance
will cycle between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will
cycle between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of
its colors.
RED: the unit is heating at the maximum power.
YELLOW: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Brightness of the display
The appliance allows two dierent brightness settings
for the display. The highest is active when any key button
is pressed. After a few seconds of keyboard inactivity, the
brightness will decrease to the operating brightness level.
This lower level can be adjusted by means of the light
button (G). Press the light button repeatedly till the
desired brightness is reached (three brightness levels
available).
Key lock
In order to avoid accidental operation, you can lock the
keyboard using the keylock function.
To activate this function press buttons + and - together for
at least 3 seconds. The display shows the symbol and
a double acoustic signal will be emitted. To disactivate the
function proceed in the same way.
Timer function
This function can be activated in two dierent ways.
Delayed start: With the appliance o, press the timer
button (F) . The symbol is displayed ashing
together with the hours left before the appliance comes on.
Change the hours using the + and - buttons, then wait a
few seconds for the program to be stored.
The display will return to o and the symbols remains
on.When the programmed time has elapsed, the appliance
will come on with the previous settings.
Delayed stop: with the appliance on, press the timer
button . The symbol is displayed ashing together
with the hours left before the appliance goes o. Change
the hours using the + and - buttons, then wait a few
seconds for the program to be stored. The current settings
and symbol are displayed. At the end of the set time
the appliance switches o automatically. To go back to
operating without the timer, press the timer button twice.
The timer symbol disappears from the display.
Please note: the time is settable from 0.5 to 24
hours.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is
in o position, press and hold the "+" and "ECO" keys for
at least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Alarms
The appliance has a diagnostic system that makes it
possible to signal malfunctions. In case of problems, the
display will show an alarm message:
(Probe failure)
With this alarm the appliance does not
operate. Contact the De'Longhi Customer
Service.
(High temperature)
When the product’s internal temperature
is too high, the heating power will
progressively and automatically
be reduced. The display shows
intermittently till the internal
temperature is lowered. To remove the
cause of this alarm check that the unit is
not covered or obstructed.

13
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The appliance doesn't work
The display shows: Ht
(High temperature)
Be sure it is plugged in and that the
electrical outlet is working.
Check for any obstruction.
The temperature may be set too low.
Probe failure, the display shows: PF
The unit is covered or obstructed.
Plug into the power outlet.
Remove the obstruction and let the
appliance cool down. If the appliance doesn't
workplease contact the De'LonghiCustomer
Service .
Set the temperature to a higher position.
Contact the De'Longhi Customer Service.
Check that the unit is not covered or
obstructed. When the product internal
temperature decreases the alarm will
disappear.
SAFETY DEVICE
A safety device switches the heater o in the event of
overheating. Please call the De Longhi customer service.
MAINTENANCE
Always remove the plug from the power outlet and allow
the radiator to cool. Wipe radiator with a soft damp cloth,
do not use detergents and abrasives.
Should the radiator not be in use over a certain length of
time, wind the cord around the cord holder and store it in a
dry place. This appliance has been built to give many years
of trouble free service. In case of malfunction or doubt, do
not try to repair the heater by yourself: this may result in a
re hazard or electric shock. Call the De'Longhi Customer
Service.