Denon DVD-1730 User manual

DVD-1730
BEFORE APPLYING THE UPDATE PLEASE
ENSURE YOU HAVE READ AND FULLY
UNDERSTAND THESE INSTRUCTIONS.
Reproduction, publication in electronic or any other form of
this software and this documentation without the express
written consent of the rightful owner is forbidden and will be
prosecuted by law.
© 2007 DENON UK
Warning:
Please read though these instructions completely before attempting to
update your player. The use of this update is completely at the owner’s
risk. DENON can not be held accountable for damage resulting to the
player or associated equipment as a result of improper use of this
update.
During the upgrade process it is imperative that you do not switch off
the unit's power and/or press any of the buttons on the unit or remote
control unless otherwise instructed.

Upgrade-Procedure:
1. If you have not done so already, please connect the DVD-
1730 to a monitor using either the Composite or S-Video
connections (Page 14 of the user manual) then turn on the
player and monitor.
2. Please ensure that you do not have any discs currently
inside the player and the draw is closed.
3. On the remote control, press the following buttons in order,
9, 8, 7, 6 and then Search Mode.
4. The draw should open automatically. Place the update disc
on the tray and then close the draw.
5. The update procedure takes approximately 5 minutes.
Please do not press any buttons or switch off the player.
6. Once the update has finished the draw will open
automatically.
Remove the update disc from the tray, unplug the DVD-1730 from the
mains then back in again.
Notes:
Your player’s settings will have been returned to their factory defaults.
Please re-configure the player (User manual page 26) to your
requirements.
Denon do not advise the loading of any non-official firmware into your
DVD player.
Doing so could compromise the features and performance of
your player.
© 2007 DENON UK Moorbridge House, Padbury Oaks, 579
Bath Road, Longford, Middlesex, UB7 0EW.
All rights reserved.