Design Within Reach Loop Dresser 100172177 User manual

Loop Collection
Designed by Earnest Studio for Design Within Reach
Customer Service:
1.800.944.2233 inside the U.S.
1.203.614.0750 outside the U.S.
1 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
BESIDE TABLETHREE-DRAWER DRESSER
SIX-DRAWER DRESSER
TOOLS (NOT INCLUDED)
For use on Wide Dresser and Three-Drawer Dresser. Comes in its
own included package.
Bracket x 2Long screw x 2
Safety strap x 1
Short screw x 2
Phillips screwdriver
SAFETY STRAP KIT

2 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
Loop Collection
2.
1.
LOWER RAISE
Cabinet is packed with sheet of MDF attached to base with leveling feet. To remove, lay
cabinet on back and remove leveling feet by turning counterclockwise. After removing MDF
sheet, return leveling feet to legs.
With cabinet in final location, check for level from side to side and front to back. Adjust leveling feet, as shown, until cabinet is level in all directions.

3 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
Loop Collection
Drawer pulls are factory installed facing inward for shipping. Remove each with a screwdriver, then reinstall facing outward.
3.

4 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
Loop Collection
To raise or lower drawer, locate knobs next to latch pins on each sllide. Turn knobs to adjust height of drawer.
4.

5 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
Loop Collection
5. Safety strap kit, included with your dresser in its own package, must be installed on the Six-Drawer Dresser and Three-Drawer Dresser. Follow instructions with kit.
Wall
Safety strap kit is
not required on
Bedside Table.
Safety strap kit

6 | WWW.DWR.COM | 1.800.944.2233 | DESIGN WITHIN REACH STUDIOS
Loop Collection
NOTE: To remove drawer, pull all the way out. Reach under drawer and locate downward protruding latch pins on drawer slides, one on each side, as shown below. Push both pins inward
toward center of drawer to release drawer from slide. Drawer can now be lifted off slides. Reverse process to reinstall.