Design Within Reach MIN User manual

ASSEMBLY INSTRUCTIONS
MIN UPHOLSTERED HEADBOARD design Luciano Bertoncini
“A” x 1
headboard
“B” x 2
upper bracket
NOTICE
Product intended to be assembled by an adult due to the presence of small parts.
Screws must be tightened and fully inserted into the frame. To achieve this we recommend holding the longer side of the hexa-
gonal key supplied and apply pressure.
USE AND MAINTENANCE
Clean metal parts of the product using a soft cloth moistened with a solution of water and mild soap; wipe dry immediately
using a soft dry cloth. Furniture cleaning products may also be used.
The colour of parts may change with exposure to direct sunlight. Do not use acids, solvents or abrasive products.
Fabric parts are removable, maintenance information on the care label.
(composition 100% PL-FR)CARE LABEL “OXY-FR” FABRIC
40 P
“C” x 2
under bracket
“E” x 2
washers
“D” x 2
M8x20 hexagon head screw
“F” x 1
hexagonal key
light washing
temperature
40° MAX
dry clean do not
bleach
do not
tumbler dry
iron with
low temperature
To remove the fabric cover, turn the headboard over and lift and pull velcro straps.

1Center upper brackets Balong frame and correctly position the distance
so that the tubular supports on headboard Aare aligned and can be inserted.
A
3Place headboard Ain the center of the bedframe.
Completely tighten screws Dwith hexagonal key F.
2Insert the under brackets Cwith the washers Eand with the screws Das shown in the figure.
Do not tighten screws completely.
B
B
B
C
E
D
F