XBee/XBee-PRO® DigiMesh 2.4 User Guide
(Part number N)
Disclaimers
Information in this document is subject to change without notice and does not represent a commitment on
the part of Digi International. Digi provides this document “as is,” without warranty of any kind, expressed
or implied, including, but not limited to, the implied warranties of fitness or merchantability for a particular
purpose. Digi may make improvements and/or changes in this manual or in the product(s) and/or the
program(s) described in this manual at any time.
Trademarks and copyright
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and
other countries worldwide. All other trademarks mentioned in this document are the property of their
respective owners.
© 2015 Digi International. All rights reserved.
Revision Date Description
A September, 2008 Baseline release.
B March, 2010 Updated to support XBee DigiMesh 2.4 firmware updates.
C February, 2011 Updating hardware and software changes.
D July, 2011 Update to Antenna Information.
E January, 2012 Added new text and images.
F April, 2013 Corrected errors.
G July, 2013 Revised confusing voltage requirements.
H July, 2013 Corrected receive options description on three API frame descriptions.
IN/A Revision I is not used.
J December, 2013 Added frames 8D and 8E frames to the API section.
K May, 2014 Quality revision.
L July, 2014 Corrected output power values from 100 mW to 63 mW. Added CA
changes, and CA command to manual.
M December, 2014 Added the table for reading 0x8D packet in the Route Information
Packet; added the max network size message in the General
Information about the XBee/XBee-PRO DigiMesh 2.4 RF Module
section; updated the Data Sample Rx Indicator section; updated the
receive options description in the Data Sample Rx Indicator table.
N March, 2015 Updated the warranty information. Added Brazilian certifications.
Corrected DD command default.
