Digi ConnectPort X4 H User manual

Quick Start Guide
ConnectPort® X4 H
Welcome to your Digi product
Get started: This guide helps you with initial product setup. Need more? Find additional
product support at www.digi.com/support/ConnectPortX4. Or connect to the online
documentation by scanning this code:
Digi Technical Support: Digi offers multiple support plans to help you get the most out of your
product. For information on Technical Support plans and pricing, contact us at 877.912.3444 or
visit www.digi.com/support.
Documentation Feedback: To provide feedback on this documentation, send your comments
to [e-mail].
1Verify your components
Included equipment
Connect Port X4 H Cellular/WiMAX antenna
Ethernet cable Wire whip antenna
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
Note If your device uses a SIM card, it must be supplied and activated by a cellular service provider for device operation.
2Open the device
Unscrew and open the lid. Be sure to note that the top of the enclosure is hinged to the base on the power cord side.
© 2017 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.

3Install SIM/Ethernet
Note If your device uses a SIM card, you must insert the SIMcard. If your device does not use a SIMcard, you can skip this step.
a. Insert the SIMcard as shown.
Install the primary SIMcard in the upper
SIMslot, with the contacts face down.
Install the secondary SIM card in the
lower slot, with the contacts face up. In
both cases, insert the end of the SIM
card with the chamfered corner first.
b. Connect one end of the Ethernet cable
to the ConnectPort X4 H and the other
end to the PC.
4Connect the hardware
a. Connect the wire whip antenna.
b. Connect the cellular antenna.
c. Power up the unit by connecting the ACpower cord to a proper power source.
d. After you have connected all the hardware, you must configure the unit. For configuration information, see the ConnectPort X4 Getting
Started Guide, which you can download from www.digi.com/ConnectPortX4.
5Complete the device setup
a. Remove power from the unit by disconnecting the power source.
b. Remove the Ethernet cable.
c. Replace the screws that were removed in Step 2.
Note Digi recommends that you use 4 to 5 inches per pound of torque when tightening the screws. You should tighten the screws in a
criss-cross pattern to ensure that the cover is not bent or skewed during this process.
a. Restore power to the unit by reconnecting the power source. The unit is now ready to use.
6Next steps
For more details about the ConnectPort X4 family, go to: www.digi.com/ConnectPortX4.