Digilin Edge 20 User manual

Edge 20 –LED Lighting Profile
Installation Guide
Document Rev: 2.1 - 10 August 2021
Product specifications are subject to change without notice
digilin.com.au ©2021 Digilin Technologies
[phone] Page 1 of 2
Notes
•Install in a dry sheltered position
•Profile is not sealed. Do not install where water or high humidity may be present without further protection.
•Installation should only be performed by a qualified professional
•Install in accordance with all appropriate wiring standards
•DALI is not SELV and needs to be wired accordingly
•Never connect a LED fitting to a driver that is powered. Doing so may result in damage to the LED.
•Always make sure the output voltage range and output current of the LED driver match the requirements of the
LED fitting. Failure to do so may result in damage both the driver and fitting.
•The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
•Do not install under mechanical stress.
•Allow for expansion due to changes in temperature.
•Please be aware that while the system has a very long operational life, faults may still occur, and provision needs to be made for maintenance.
•Always turn off power before working on fitting.
Specifications
U n i t s
Dimensions
20 x 20
mm
Length
Custom
Weight
200
g/m
Wiring Diagram

Edge 20 - LED Lighting Profile
Installation Guide
digilin.com.au
[phone] Page 2 of 2
Installation
1. Connect power and feed cables as required.
2. Secure the lower extrusion (mounting tray)
into position using appropriate fasteners
(head height of no more than 3.5mm). Take
care no to place a screw directly below the
cable entry point.
3. Press the main extrusion into the mounting
tray.
4. Replace the end cap where applicable.
5. Turn on Power
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at www.digilin.com.au