Digisol DG-BR5411QAC User manual

SOP for REPEATER Mode
DG-BR5411QAC
Hardware ver . A1 Firmware : RF014
SOP version : 1.0
Standard/Channel Release

Application Scenario
Wireless PC Repeater Internet / Main
Router

Configuration of Repeater
STEP 1 : Access Web Interface
Please connect your PC to DG-BR5411QAC via wireless or wired.
Open the web browser and type the IP address http://digisol.ap or
http://192.168.2.1 into the address bar and then Press Enter key.

Type the username and password into the boxes of the login page, and the
default username and password are admin and 1234 , then press Enter.
Note:
the default working mode of DG-BR5411QAC is router mode, so its web
interface can only be logged in through wireless connection on default
settings.

STEP 2 : Go to NETWORK > LAN page
Disable the DHCP server
Next Click “Apply Changes” button and then Click “Reboot Later “
Please Note :Incase in future if you want to Modify/view the settings of
Repeater then you need to Manually Add the IP Address (eg ;
192.168.2.10 ) to the PC/Laptop/Smartphone
Or else You can Factory reset the repeater to reconfigure.
Please Note :Incase in future if you want to Modify/view the settings of
Repeater, then you need to Manually add the IP Address (eg ;
192.168.2.10 ) to the PC/Laptop/Smartphone
Or else You can Factory reset the repeater to reconfigure.

STEP 3 : Setup Wireless Name/Key (optional)
Go to WLAN1_5G and WLAN2_2.4G
As per customer requirement, Please set/customize the Wireless SSID and
Password for Repeater , for both WLAN1_5G and WLAN2_2.4G bands.
This is an optional step .
This setting is only for the repeater , not for the Root / Main AP.
•

STEP 4: Go to > WLAN1_5G > BASIC SETTING
Select Universal Repeater mode
Next Click “Apply Changes” button
Next Click “Reboot Later” button

Go to SITE SURVEY page (on leftside menu)
Click “Site Survey” Button
Select the SSID of Main/ Root AP
Click “Next>>” button

Type the Wi-Fi password of the Root AP or MAIN Router into the
Pre-shared Key field and
Click Connect button.

Select “Add to wireless Profile”
Click “Reboot Now” button
The device will reboot …………. with new settings to apply.
You may also Power cycle to reboot the Repeater.