Diode Dynamics C-Light LED Halos User manual

2015-17 Subaru WRX/STi
C-Light LED Halos Installation Guide
Please contact Diode Dynamics should you have any questions about the installation
or wiring process, at 314-205-3033 (9a-5p CST) or [email protected].
PAGE 3 [phone] WWW.DIODEDYNAMICS.COM
Scan the QR code to link to our installation video online!
NEED MORE HELP?
We’ve taken the time to test our products on your vehicle. We can
guarantee compatibility and tment the rst time – no guessing
game! If you need more help with installation, watch our step-by-step
video to walk you through the process.
GUARANTEE
100% SATISFACTION
Visit www.diodedynamics.com to nd more products for any vehicle.
WARRANTY
3 YEAR
8. First, connect the board connector to the Switchback driver output. Connect the
Switchback driver input to the pigtail. Finally, tap the bare wires to the wiring harness.
See Wiring Method Diagram below. The black wire must be grounded before any
function will work.
IMPORTANT: DO NOT plug the LED panel directly into pigtail without the driver. The
LEDs must be plugged into driver rst to control the power.
9. Mount driver and tuck all wires. Driver should be mounted outside of headlight for
serviceability, in a location away from the engine block to avoid excessive heat buildup.
10. Test thoroughly, reseal headlight and reinstall onto vehicle.
Wiring Instructions

4. Install your new Diode Dynamics C-Light by running
the wires through the hole where the factory bulb
was and setting the LED board into place.
5. Reinstall the reector lens into the bezel by
aligning the clear clips and snapping them back into
their original position. Align all of the clips at once.
7. Reinstall the lens on the headlamp assembly by
running the wires through the existing factory hole or
grommet. Set the lens into place and apply pressure
to snap the original clips back into place. Reinstall the
original screws and repeat for the other headlamp.
Thank you for your purchase of this unique product for your Subaru
WRX or STi! With these modules, you will be able to convert your
C-Light inside the headlight into a white running light, along with an
amber turn signal feature.
1. Remove the lens and set the headlamp assembly
aside. Next, remove the 3 screws holding the bezel to
the lens. Then remove the bezel from the headlight
lens.
2. Bring the bezel to a soft, non-marring working
surface. Then unclip the reector lens from the bezel
by squeezing the clear clips with a pair of pliers and
pushing downward on them.
3. Pull the reector lens straight out to remove it and
set it aside.
See back for further instructions.
Tools Needed: Phillips Screwdriver and Pliers
PAGE 1 PAGE 2
[phone] WWW.DIODEDYNAMICS.COM
WARRANTY
3 YEAR
Please note: Headlights must be opened before proceeding with installation. Professional installation
is strongly recommended. Please contact Diode Dynamics if you need assistance locating an installer.
WATCH THE INSTALLATION VIDEO ONLINE!
Scan the QR code on page 3
2015-17 Subaru WRX/STi
C-Light LED Halos Installation Guide
2015-17 Subaru WRX/STi
C-Light LED Halos Installation Guide
6. Using a microber cloth, remove any nger prints
that may be on the bezel then reinstall it back into the
headlight lens by clipping it into place. Reinstall the
original screws.