Diode Dynamics DD0438 User manual

PAGE 1 [phone] WWW.DIODEDYNAMICS.COM
Universal Footwell LED Kit
Installation Guide
Thank you for purchasing the Diode Dynamics LED Footwell Kit!
Please watch our installation video on YouTube prior to installation.
Tools Needed: Drill with 3/4” bit, Needle Nose Pliers, Phillips Screwdriver, Flathead
Screwdriver, Socket Wrench Set
1. Locate a 12 volt power source and ground. Often times, this can be found on your
12V outlet/cigarette lighter, or your vehicle’s ignition.
2. Using the provided red quick-splice connectors, splice the red power wire and
the black ground wire to the 12V power source and ground located in step one.
3. Connect the strips to the wiring harness:
Multicolor RGBW Kit: Plug the DC connector into the included DC-to-DT adapter
wire. Then plug the DT connector into your RGBW controller. Plug the M8 connector
on each strip into the controller.
Single Color Kit: Insert the red (+) and black (-) wires on each strip into the positive (+)
and negative (-) slots on the green tip of the DC screw terminal. Plug each DC screw
terminal into the splitter wire. Then plug the splitter wire into the DC connector .
4. Connect the pink spade connectors to the silver pins on the back of the switch.
Connect the additional ground wire to the copper pin on the switch, and ground it
to any bare metal bolt .
WARRANTY
3 YEAR
A
D
B
C
B
A2
A1

PAGE 2 [phone] WWW.DIODEDYNAMICS.COM
Universal Footwell LED Kit
Installation Guide
Scan the QR code to link to our installation video online!
NEED MORE HELP?
We’ve taken the time to test our products on your vehicle. We can
guarantee compatibility and tment the rst time – no guessing
game! If you need more help with installation, watch our step-by-step
video to walk you through the process.
1. If your kit is not illuminating:
A. Check that your power and ground connections have full connection
and a solid ground.
B. Try swapping the power and ground connections , referred to as
ipping your polarity.
C. Check that the spades are both on the silver male prongs on the
switch, and the additional ground is on the copper pin.
Troubleshooting
DC
DC
Please contact Diode Dynamics should you have any questions about the installation
or wiring process, at 314-205-3033 (10a-5p CST) or [email protected].
A2
A1
GUARANTEE
100% SATISFACTION
WARRANTY
3 YEAR
PP0118C
DD0228 Blue LED Footwell Kit
DD0229 Red LED Footwell Kit
DD0232 Cool White LED Footwell Kit
This installation guide is for the following SKU:
DD0438 RGBW Footwell Strip Kit 2pc
DD0443 RGBW Footwell Strip Kit 4pc
5. Test your system for proper function. If you purchased the multicolor kit, your kit
should cycle through red, green and blue.
6. Mount your LED strips using the provided mounting options.