DirectOut Technologies EXBOX.MD User manual

EXBOX.MD
User‘s Manual
Version 1.0

page 2 of 60
EXBOX.MD Manual - Version 1.0
Copyright
All rights reserved. Permission to reprint or electronically reproduce
any document or graphic in whole or in part for any reason is
expressly prohibited, unless prior written consent is obtained from the
DirectOut GmbH.
All trademarks and registered trademarks belong to their respective
owners. It cannot be guaranteed that all product names, products,
trademarks, requisitions, regulations, guidelines, specifications and
norms are free from trade mark rights of third parties.
All entries in this document have been thoroughly checked; however
no guarantee for correctness can be given.
DirectOut GmbH cannot be held responsible for any misleading or
incorrect information provided throughout this manual.
DirectOut GmbH reserves the right to change specifications at any time
without notice.
DirectOut Technologies® is a registered trademark of the DirectOut
GmbH.
© DirectOut GmbH, 2018

page 3 of 60
EXBOX.MD Manual - Version 1.0
Table of contents
About This Manual 5
How to Use This Manual 5
Conventions 5
Chapter 1: Overview 6
Introduction 6
Feature Summary 7
Applications 8
How it works 9
CHAPTER 2: Legal issues & facts 10
Before Installing This Device 10
First Aid (in case of electric shock) 11
Defective Parts/Modules 12
Updates 12
Intended Operation 13
Conditions of Warranty 14
Conformity & Certificates 15
Contact 16
Contents 17
Accessories 18
Chapter 3: Installation 21
Installing the Device 21
CHAPTER 4: Operation 27
Introduction 27
Global Control 28
Input / Output - MADI 31

page 4 of 60
EXBOX.MD Manual - Version 1.0
Input / Output - Network 32
Input State / Clocking 34
Sample Rate 36
State 38
CHAPTER 5: Remote Control 39
Dante Controller 39
EXBOX.MD Remote 46
CHAPTER 6: Troubleshooting and Maintenance 49
Troubleshooting 49
Maintenance 51
CHAPTER 7: Technical Data 52
Appendix A - Wiring Sketches 55
Hirose HR10 (DC PSU) 55
Index 56

page 5 of 60
EXBOX.MD Manual - Version 1.0
About This Manual
About This Manual
How to Use This Manual
This manual guides you through the installation and
operation of the device.
Use the Table of Contents at the beginning of the
manual or Index Directory at the end of the document
to locate help on a particular topic. You can access
more information and latest news by visiting on the
DirectOut website at www.directout.eu.
Conventions
The following symbols are used to draw your
attention to:
TIPS!
indicate useful hints and shortcuts.
NOTES!
are used for important points of clarification or cross
references.
WARNINGS!
alert you when an action should always be observed.

page 6 of 60 EXBOX.MD Manual - Version 1.0
Chapter 1: Overview
Chapter 1: Overview
Introduction
EXBOX.MD is an Audio-over-IP to MADI converter
based on Audinate’s audio networking technology
Dante.
Equipped with three MADI ports and four network
ports it offers straight-forward conversion of 64 audio
channels between MADI and Dante.
Interfaces:
• 3 MADI I/Os
• 4 Network ports (3 standard / 1 PoE)
The built-in network switch gives the opportunity
to use Dante’s redundancy mode (Primary <>
Secondary), while more EXBOX.MDs or other Dante
devices can be connected in switched mode directly
to increase the number of channels.

page 7 of 60
EXBOX.MD Manual - Version 1.0
Chapter 1: Overview
Feature Summary
MADI Ports 1 x SC multi-mode connectors *
1 x SFP (empty cage without module)
1 x coaxial BNC connectors
Network 3 x RJ45 Socket (1 Gbit/s),
1 x RJ45 (1 Gbit/s, PoE)
Number of streams 32
Number of channels 64 @ 1 FS, 32 @ 2 FS, 16 @ 4 FS
Network Standards Dante, AES67
Modes Switched or Redundancy
Remote Dante Controller, EXBOX.MD Remote
MADI Formats 56/64 channel, 48k/96k Frame, S/MUX 2/4
Sample Rates 44.1, 48, 88.2, 96, 176.4, 192 kHz +/-
12.5%
Power Supply external,
2 x Hirose connector (9-24 V)
1 x PoE (Power over Ethernet)
* The SC I/O may be ordered as single-mode upon
request.

page 8 of 60
EXBOX.MD Manual - Version 1.0
Chapter 1: Overview
Applications
EXBOX.MD can be used as an easy to use frontend
for bidirectional signal exchange between Dante and
MADI environments.
Typical applications include:
• Integration of MADI in Dante setups
• Redundant recording setups using MADI and
Dante Virtual Soundcard
• Mixing and monitoring using redundant Dante
links between stage and FOH

page 9 of 60
EXBOX.MD Manual - Version 1.0
Chapter 1: Overview
How it works
Each MADI port and the Dante input can be selected
as source for any output.
The network audio is controlled via the Dante
Controller software provided by Audinate.
SFP
BNC
SC
Dante
SFP
BNC
SC
Dante
Dante MADI
Routing
EXBOX.MD
Routing
Dante Controller

page 10 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
CHAPTER 2: Legal issues & facts
Before Installing This Device
WARNING!
Please read and observe all of the following notes
before installing this product:
• Check the hardware device for transport
damage.
• Any devices showing signs of mechanical
damage or damage from the spillage of liquids
must not be connected to the mains supply,
or disconnected from the mains immediately by
pulling out the power lead.
• All devices must be grounded. The device is
grounded through its IEC power connections.
• All devices must be connected to the mains
using the three-cord power leads supplied with
the system. Only supply electrical interfaces
with the voltages and signals described in these
instructions.
• Do not use the device at extreme temperatures.
Proper operation can only be guaranteed
between temperatures of 5ºC and 45ºC
and a maximum relative humidity of 80%, non-
condensing.
• The cabinet of the device will heat up. Do not
place the device close to heating sources (e.g.
heaters). Observe the environmental conditions.

page 11 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
First Aid (in case of electric shock)
WARNING!
• Do not touch the person or his/her clothing
before power is turned off, otherwise you risk
sustaining an electric shock yourself.
• Separate the person as quickly as possible from
the electric power source as follows:
- Switch off the equipment.
- Unplug or disconnect the mains cable.
• Move the person away from the power source
by using dry insulating material (such as wood or
plastic).
• If the person is unconscious:
- Check their pulse and reanimate if their
respiration is poor.
- Lay the body down and turn it to one side.
Call for a doctor immediately.
• Having sustained an electric shock, Always
consult a doctor.

page 12 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Defective Parts/Modules
WARNING!
This device contains no user-serviceable parts.
Therefore do not open the device.
In the event of a hardware defect, please send the
device to your DirectOut representative together with
a detailed description of the fault.
We would like to remind you to please check
carefully whether the failure is caused by erroneous
configuration, operation or connection before sending
parts for repair.
Updates
DirectOut products are continually in development,
and therefore the information in this manual may be
superseded by new releases. To access the latest
documentation, please visit the DirectOut website:
www.directout.eu.
This guide refers to firmware version 1.1.

page 13 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
WARNING!
No compensation can be claimed for damages
caused by operation of this unit other than for the
intended use described above. Consecutive damages
are also excluded explicitly. The general terms and
conditions of business of DirectOut GmbH are
applied.
Intended Operation
EXBOX.MD is designed for conversion / routing
between network audio and MADI signals. MADI
refers to AES10, network audio refers to Dante™
from Audinate.

page 14 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Conditions of Warranty
This unit has been designed and examined carefully
by the manufacturer and complies with actual norms
and directives.
Warranty is granted by DirectOut GmbH over the
period of 36 months for all components that are
essential for proper and intended operation of the
device. The date of purchase is applied for this period.
Consumable parts (e.g. battery) are excluded from
warranty claims.
WARNING!
All claims of warranty will expire once the device
has been opened or modified, or if instructions and
warnings were ignored.
For warranty claims please contact the dealer where
your device was acquired.

page 15 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Conformity & Certificates
CE
This device complies with the basic requests of
applicable EU guidelines. The appropriate procedure
for approval has been carried out.
RoHS
(Restriction of the use of certain Hazardous
Substances)
This device was constructed fulfilling the directive
on the restriction of the use of certain hazardous
substances in electrical and electronic equipment
2002/95/EC.
WEEE
(Directive on Waste Electrical and Electronic
Equipment)
Due to the directive 2002/96/EC for waste disposal
this device must be recycled.
For correct recycling please dispatch the device to:
DirectOut GmbH,
Leipziger Str. 32
09648 Mittweida
Germany
Only stamped parcels will be accepted!
WEEE-Reg.-No. DE 64879540

page 16 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Contact
DirectOut GmbH
Leipziger Str. 32, 09648 Mittweida, Germany
Phone: [phone]
Fax: [phone]
Mail: [email protected]
www.directout.eu

page 17 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Contents
The contents of your EXBOX.MD package include:
• 1 x EXBOX.MD
• 1 x external power supply unit (9 - 24 V)
• 1 x Manual
To complete the delivery, download the Dante
Controller software from Audinate's website.
Link: http://www.audinate.com

page 18 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
Two different optical SFP modules are available from
DirectOut GmbH:
• Multimode SFP transceiver with LC connectors
(No: DOICT0129)
• Singlemode SFP transceiver with LC connectors
(No: DOICT0130)
Specification of the optical SFP modules:
SFP Multimode Singlemode
Wavelength TX 1310 nm 1310 nm
Wavelength RX 1310 nm 1310 nm
Distance 2 km 10 km
Powerbudget (dB) 11 dB 12 dB
Protocols Fast Ethernet OC3/
STM1
Gigabit Ethernet,
Gigabit Fibre
Channel
Bandwidth from 100 Mbit/s 1.050 Gbit/s
Bandwidth 155 Mbit/s 1.250 Gbit/s
Laser FP FP
Receiver Type PIN PIN
Connector LC LC
Accessories

page 19 of 60
EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
SFP Multimode Singlemode
Wavelength TX min 1260 nm 1260 nm
Wavelength TX max 1360 nm 1360 nm
Wavelength RX min 1260 nm 1260 nm
Wavelength RX max 1620 nm 1600 nm
Transmit min - 19.00 dBm - 9.00 dBm
Transmit max - 14.00 dBm - 3.00 dBm
Receive min - 30 dBm - 21.00 dBm
Receive max
(Receiver overload)
- 5.00 dBm - 3.00 dBm
Temperature (min) 0° Celsius 0° Celsius
Temperature (max) 70° Celsius 70° Celsius
Type of DDM/DOM internal internal
Extinction Ratio 8.20 dB 9 dB

page 20 of 60 EXBOX.MD Manual - Version 1.0
CHAPTER 2: Legal issues & facts
BOX.MOUNT XL- for optimal rack mount of up to
three devices in a 19’’ frame (No: DOAPA0886):
three devices in a 19’’ frame (No: DOAPA0886):