Displays2go IPDTBL3 User manual

iPad IPDTBL3
Assembly Instructions

1
Carefully lay all posts horizontally on floor. Insert 4 foot screws
into 4 posts except 1m post with connector bars.
WARNING – Dome-headed
chrome nuts behind enclosure
housing must not be adjusted.

3Feed figure-8 head of
power lead through
bottom of post and
profiles assembly, leaving
approximately 1m of
cable at bottom.
4Stand post and profiles
assembly upright ensuring
lead is kept clear of foot
screws.
Take 265mm post and slot clamp of three 220mm profiles into
desired channels for display. Ensure bottom of profiles are flush
with bottom of post and tighten grub screws to secure in position.
If you are not using cable management for charging, please
carefully stand post and profiles assembly upright and proceed to
Stage 6
2

5
Feed figure-8 head of power lead through 1m post at connector
bar end, so it protrudes from top of post.
Loosen and slide connector bars halfway out of 1m post. Tighten
grub screws of connector bars positioned in post channel to secure
6

7
Connect the 1m and 265mm posts by locating connector bars into
channels and sliding together. Tighten remaining grub screws to
affix.
With countersunk holes in the Podium tops uppermost, align with
holes of circular plates and fixings in the top of remaining small,
medium and large posts. Fully insert 4 screws in each to secure.
8

9
Starting with the smallest Podium table, position and slot clamp of one
220mm profile into post channel. Tighten grub screw to attach. Repeat
process for medium and large Podium tables.

11
Plug figure-8 head into USB Power Adapter (supplied with Apple
iPad).
Position remaining 220mm profiles between posts near underside
of Podium tops. Insert clamps into channels and secure by
tightening grub screws.
If you are not using cable management for charging, please
proceed to Stage 17.
10

13
Lift fascia out of enclosure. Insert cable (supplied with Apple iPad)
allowing 10cm to remain “free” at charge/sync connector end by
gently pressing into retaining moulding.
12
Unlock the iPad enclosure by inserting key into security lock and
rotate ‘QUARTER TURN ONLY’ clockwise or counter-clockwise
through 90 degrees which releases the locking pin. Return key back
to original position to remove.

15
Plug cable into USB Power Adapter.Feed USB end of charge/sync cable through middle of enclosure,
below pin, so it protrudes from bottom of support column.
14

17
Align first 2 holes of the iPad holder to the threads of the post.
Insert and tighten screws to secure. Rotate iPad holder through 90º,
aligning remaining 2 holes to threads of post. Insert and tighten
screws to secure.
Position black mains cable into internal post channel, and carefully
slide USB Power Adapter inside post so the USB head of charge/sync
cable is below upper edge of post.
16