Displays2go TVM110B User manual

TVM110B
Landscape VESA Max 800*600
Portrait VESA Max.400*600
46-110"
76-152cm
Max
125kg
[275Ibs]

WARNING
!
Do not begin the installation until you have read and understood the instructions and
warnings contained in this installation sheet. If you have any questions regarding any of the
instruction or warning, please contact your local distributor.
This mounting bracket was designed to be installed and utilized ONLY as specified
in this manual. Improper installation of this product may cause damage or serious
injury.
This product should only be installed by someone of good mechanical ability with
basic building experience and full understanding of this manual.
Make sure that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components. Never exceed the maximum load
capacity. If mounting to wood wall studs, make sure that mounting screws are anchored
into the center of the studs. Use of a stud finder is highly recommended.
Always use an assistant or mechanical lifting equipment to safely lift and position
equipment.
Tighten screws firmly, but do not over tighten. Over tightening can damage the items,
greatly reducing their holding power.
NOTE:Read the entire instruction manual before you start installation and assembly.

2PCS 1PCS 1PCS 1PCS
1A
Landscape Installation
VESA MAX 800X600
600
800
www.displays2go.com
12 3 4
B
A C D
E F G
M6X15
4PCS
M5X15
4PCS
M8X15
4PCS
M10X15
4PCS
10X70
8PCS
12X70
8PCS
M6
4PCS
M5
4PCS
M8
4PCS
M10
12PCS
8mm
1PCS
6mm
1PCS
5mm
1PCS
17mm
1PCS
14mm
1PCS
4mm
1PCS 15X 8X15
4PCS

2
3A
www.displays2go.com
24
3
2
4
3
C
DB
Solid Brick and Concrete Block Mounting
Use a level to create an even line and a drill
to make pilot holes. Ensure the concrete is
at least 70mm deep.

24
3
C
Wood Stud Wall Mounting
3B
Installed on the wall
www.displays2go.com
Use of a stud finder is highly
recommended when mounting to a wall
with wood studs. Use a level to create an
even line and a drill to make pilot holes.
Ensure the studs are at least 70mm deep.

www.displays2go.com
4
E
G
A
D
Use included spacers if you have a
recessed back TV.

5
6
A
D
WALL
Level the flat screen by adjusting
M8x200mm level adjustment screw
Hook screen onto the wall plate
FLAT SCREEN
LATERAL ADJUSTMENT
BY HAND
www.displays2go.com
1
Wire Locking System

V E S A M A X 4 0 0 X 6 0 0
1B Portrait Installation
2A
70mm
Φ12mm
Mount to the concrete wall
400
600
www.displays2go.com
2
Solid Brick and Concrete Block Mounting
Use a level to create an
even line and a drill to
make pilot holes.
Ensure the concrete is
at least 70mm deep.
CDB

Use included spacers if you have a
recessed back TV.
Wood Stud Wall Mounting
2
2B
3
Installed on the wall
www.displays2go.com
Use of a stud finder is highly
recommended when mounting to a
wall with wood studs. Use a level
to create an even line and a drill to
make pilot holes. Ensure the studs
are at least 70mm deep.
CDB
E
G
A
D

4
5
WALL
Level the flat screen by adjusting
M8x200mm level adjustment screw
A
D
Hook screen onto the wall plate
LATERAL ADJUSTMENT
BY HAND
FLAT SCREEN
www.displays2go.com
1
Wire Locking System

www.displays2go.com