Displays2go ECOSOC66 User manual

EECOSOC66COSOC66
Assembly InstructionsAssembly Instructions
Eco cork Standoff SignagEEco cork Standoff SignagE
ECOSOC8511ECOSOC8511
ECOSOC1117ECOSOC1117

2
PARTS LIST
PART QUANTITY
A: Signage .............................................1
B: Standoff..............................................4
C: Wall Anchor Set................................4
D. Screw and Nut Set............................4
E. Allen Key ............................................1
Tools required: Power drill, bubble level,
hammer, phillips screw driver.
If you have any questions regarding our products, please visit us at www.displays2go.com or
contact Displays2go customer service at 844-221-3388.
A
B
ECOSOC66 ECOSOC8511 ECOSOC1117
C
D E
Scan QR code to
visit product page

3
1. Place your acrylic signage against the wall and make sure the signage is level on the wall.
Hold the signage and mark the the center of each hole on the wall. Remove the acrylic
signage and drill holes at the marked locations.
Wall Mounting
2. Insert wall anchors into drilled holes and gently tap each anchor into the wall with a
hammer until it’s flush with the wall. Attach the cork backer to the wall and use anchor
screws to fix standoff bases.

4
3. Attach the printed signage to standoff bases and replace the standoff caps to secure the sigange.
The assembly is finished.
1. Use the cap nut and screw sets to fix standoff bases to the cork backer. Tighten all screws with
the allen key provided.
Tabletop Display

5
CONTACT INFORMATION:
www.displays2go.com
PHONE: [phone]
2. Align holes on the printed acrylic with standoff bases, use standoff caps to fix your signage
to the cork backer.
3. Choose either protrait or landscape display and insert the acrylic support into the
appropriate back slot.
4. The assembly is finished.