dji Phantom 2 Vision + User manual

Manual DJI Phantom 2 Vision Dronexpert Gimbal
V2

1. Remove battery from the phantom.
2. Place the Phantom upside down.
3. Pull the jackplug out of the camera
4. Lift the frame carefully from rubber holders. Pay attention to the wire
connected to the camera.

5. Disconnect the camera connector
6. Remove the “X-frame”for the Phantom body
7. You have now removed camera and frame

8. Remove white rubber cover and remove the screw
9. Remove the vision camera from the frame
10. Remove the plastic inlay
11. Return the screw with the inlay back in the frame so you don’t lose it.
12. Place the outside rubber cover back on the Vision camera.

Overview photo

13. Now take the gimbal and included parts out of the case
14. Put rubber tubes in the camera (where screws are located). Press the
tubes all the way down to the end.
15. Place the camera (jack) connector as show on the images

16. Place the screws in the rubber tubes as shown on the image

17. Now put the jack connector into the vision camera.
(make sure you press it to the end! If not pressed to the end the gimbal/camera will not work properly.)
IMPORTANT: Make sure the sensor plate is mounted horizontal, also make
sure the flat cable is free of moving space
Make sure cable is flat to camera, so that the camera has enough moving
space. If cable is blocking the movement space the camera will
'jittery' or 'shake/jump' when recording.

18. Paste the signalselector on the belly of the Phantom as shown on the
image and connect it. Make sure you keep enough space for your
Phantom battery.
19. Move the compass to a lower position (a few mm is enough)
Make sure the compass is not on the same line of the engine of the gimbal. If it is, then place the
compass lower than the motor so that it has free space to 'look'. Also make sure you calibrate the
compass before flying.