dji Flamewheel F450 User manual

FlameWheel450
User Manual
V 1.7
www.dji-innovations.com

2
Disclaimer
Read this disclaimer carefully before using FlameWheel450. By using this product, you hereby agree to
this disclaimer and signify that you have read them fully. FlameWheel450 is an excellent multi-rotor. With
a good autopilot, it will even offer tremendous flight features for low altitude flight working in restricted
space. Despite the controller of autopilot operate in the safest manner when the main power battery is
connected, we strongly recommend customers to remove all propellers, use power supply from R/C
system or flight pack battery, and keep children away during system calibration and parameter setup.
Please respect the AMA’s National Model Aircraft Safety Code. Dajiang Innovation Technology Co. Ltd.
assumes no liability for damage(s) or injuries incurred directly or indirectly from the use of this product.
F450 Profile
FlameWheel450 (F450) is a multi-rotor designed for all pilots for fun or AP. With DJI WKM or NAZA
autopilot system, it can achieve hovering, cruising, even rolling and other flight elements. It can be
applied for entertainment, aerial photography, FPV and other aero-modeling activities.

3
Contents
Disclaimer.......................................................................................................................2
F450 Profile....................................................................................................................2
Contents.........................................................................................................................3
Product Usage Cautions.................................................................................................3
In Box.............................................................................................................................4
Tools Needed .................................................................................................................5
ESC Wiring.....................................................................................................................5
Assembly........................................................................................................................6
ESC Sound Introduction.................................................................................................7
Specifications.................................................................................................................7
Product Usage Cautions
When flying, the fast rotating propellers of FlameWheel450 will cause serious damage and injury.
Therefore, please fly with a high safety consciousness.
1. Keep flying multi-rotor away from objects, such as obstacles, human beings, high-voltage
lines and so on.
2. Do not get close to or even touch the working motors and propellers, which will cause
serious injury.
3. Do not over load the multi-rotor.
4. Check whether the propellers and the motors are installed correctly and firmly before flight.
5. Make sure the rotation direction of each propeller is correct
6. Check whether all parts of multi-rotor are in good condition before flight. Do not fly with old
or broken parts.
7. Use DJI parts as much as possible.
If you have any problem you cannot solve during installation, please contact our customer
service.

4
In Box
Top Board 450FBT ×1
Bottom Board 450FBB ×1
Frame Arms 450FAC ×2
10in Propeller Pairs 450P10×2
Frame Arms 450FAW ×2
8in Propeller Pairs 450P08×2
Motors 450MOT ×4
ESC 450ESC ×4
30A
OPTO
+
-
U
V
W
Screws 450-M3×8 ×16
Screws 450-M2.5×5 ×24
Magic Strap 450MSX ×1, Battery Band 450BBX ×1
Power Line Pair 450PLP ×1

5
Tools Needed
2.0mm Hex Wrench
For frame and motors installation.
Screw Glue
For fastening screws.
Nylon Cable Tie
For binding devices and wires.
Scissors
Diagonal Cutting Pliers
Foam Double Sided Adhesive Tape
For fixing receiver, controller and other modules.
Soldering-iron & wires
For connecting ESCs’power cables to bottom board.
ESC Wiring
ESC
ESC
ESC
ESC
To Battery
Please solder ESCs to bottom board as the up figure shows. Use any insulating method at all soldering
spots. Make sure there is no short or open circuit. Make sure the side with bonding pads is upward.
Power Pads

6
Assembly

7
ESC Sound Introduction
ESC State
Sound
Ready
♪1234567
Throttle stick is not at bottom
BBBBBB…
Input signal abnormal
B--------B--------B…
Input voltage abnormal
BB---BB---BB---BB…
Tips:
DJI ESCs are specially designed for multi-rotors. When use with DJI autopilot systems, you do not
have to setup any parameters or calibrate travel range.
Specifications
Frame
Diagonal Wheelbase
450mm
Frame Weight
282g
Takeoff Weight
800g ~ 1600g
ESC
Current
30A OPTO
Signal Frequency
30Hz ~ 450Hz
Battery
3S ~ 4S LiPo
Motor
Stator size
22×12mm
KV
920rpm/V
Propeller
10 ×4.5in (@3S); 8 ×4.5in (@4S)

8
FlameWheel 450
©2010-2011 Dajiang Innovation Technology Co. Ltd. All Rights Reserved.
6/F, HKUST SZ IER Building, No.9, Yuexing 1st Rd.,
South District, Hi-Tech Park, Shenzhen, 518057, Guangdong, China
Tel: [phone] Sales ext 201, 202, 203
Fax: [phone] Service hotline:[phone]
Sales:[e-mail] Technical support: [e-mail]
Others:[e-mail]
DJI FLAME WHEEL is registered trademark of Dajiang Innovation Technology Co. Ltd. Names of product, brand, etc.,
appearing in this manual are trademarks or registered trademarks of their respective owner companies. This product and
manual are copyrighted by Dajiang Innovation Technology Co. Ltd. with all rights reserved. No part of this product or
manual shall be reproduced in any form without the prior written consent or authorization of Dajiang Innovation
Technology Co. Ltd. No patent liability is assumed with respect to the use of the product or information contained herein.