Dolphin Excel User manual

1 2 3 Use paper image on the
back of this page to
mark holes
5
Products arrives locked,
use key and push button
open
8” / 205mm minimum
x 4
x 4
6
t
Drill holes or used existing ones to fix
Remove transit cap from soap cartridge
Make sure pump is pushed in/down
Make sure
dispenser is level
SOAP DISPENSER INSTALLATION INSTRUCTIONS
4Close dispenser face and activate until product
dispenses to ensure pump is primed.
Locate cartridge with key into chassis housing.
X5
Fixing set
t
t

SOAP DISPENSER INSTALLATION INSTRUCTIONS
CLEANING AND MAINTENANCE
Clean exterior surfaces of the dispenser using
warm water and mild soap. DO NOT USE
ABRASIVE CLEANSERS. Dry with soft cloth
PRECAUTIONS
1. It is the installer’s responsibility to ensure
installation of unit comples with all applicable
codes, standards and regulatory requirements.
2. Do not install this dispenser above heat sources
or near sources of ignition/ flame.
3. Do not install where failure of the mounting
system or dripping of product from hands may
cause damage to equipment or create a
potential safely hazard.
272.2
112.3