Dolphin BC 5262 User manual

BC 5262 Dolphin Behind Mirror Hot Air
Hand Dryer and Paper Towel Dispenser
Please read carefully before use
DOLPHIN

Combination Units
Behind Mirror
DOLPHIN
340
300 42
26
BC 5262-102 Hot Air Hand Dryer
BC 5262-102 Behind Mirror Hot Air Hand Dryer can be
fitted and removed from below
BC 5262-103 Behind Mirror Paper Towel Dispenser
can be fitted and removed from below
One universal bracket suits both
products
Robust manufacture and security
fixings minimise vandalism
Simple installation and removal
26 120 298
130
6-10
33 84
257
257
224
224
BC 5262-103 Paper Towel Dispenser
BC 5262 User Manual www.dolphindispensers.co.uk

Operating Voltage
Warm Air Volume Output
Warm Air Temp Output
Motor Type
Motor Thermal Protection
Heater Element
Heater Thermal Protection
Drying Time
Circuit Operation
Sensor Range
Time Protection
Time Duration
Cover Type
Cover Finish
Net Weight
Shipping Weight
Unit Size
314.5m³/h (185 CFM)
60°C at ambient T=20°C
¼ HP, 7500 rpm, Brush Type, 200W, Dual Ball Bearings
Auto Resetting Thermostat turns unit off at 105°C (221°F)
2200W
Auto Resetting Thermostat turns unit off at 87°C (189°F)
Thermal fuse cuts unit off at 141°C (286°F)
Less than 15 seconds
Infrared Automatic, self adjusting
Adjustable;standard 18 cm± 2 cm
1 minutes auto shut off
2 seconds delayed turn off after last sensor read
Stainless steel, 1.5 mm thick
Stain finished
4.5 kg [9.9 lbs]
5.5 kg [12.1 lbs]
W x H x D [278mm x 418mm x 133.5mm]
230-240 Vac,50/60Hz,2.2-2.4Kw
Operating Instructions and Parts Manual (Automatic)
Surface Mount
AUTOMATIC HAND DRYER
340
120
224
Unıt:mm
BC 5262 User Manual www.dolphindispensers.co.uk

Operation
No-touch operation
Shake excess water from hands.
Place hands under the outlet to start operation.
Rub hands lightly and rapidly.
Stops automatically after hands are removed.
Operating Instructions and Parts Manual
Hand Dryer
Periodic cleaning of the unit is recommended to ensure optimum performance.
Cleaning and Maintenance
Disconnect the electrical supply.
Remove the two cover-mounting screws.
Remove the cover.
Clean all dust lint from the interior of the dryer.
Wipe the cover with a damp cloth and mild
cleaning solution. Do not Soak. Never use
abrasives to clean the cover.
Replace the cover. Do not over tighten the screws.
Recommended mounting heights - from bottom edge of dryer above finished floor (AFF)
Men
Women
Children 4-7 years
Children 8-10 years
Children 11-13 years
Children 14-16 years
Handicaped
(40")
(38")
(32")
(34")
(36")
(38")
(34")
1000 mm
960 mm
812 mm
860 mm
910 mm
960 mm
860 mm
Surface-mounted hand dryer
BC 5262 User Manual www.dolphindispensers.co.uk
Important: minimum mounting height above counter or surface beneath – 300mm

Diagram
Operating Instructions and Parts Manual
Hand Dryer Surface-mounted hand dryer
BC 5262 User Manual www.dolphindispensers.co.uk

DOLPHIN
Bell-Chem Products Company
Haywood Way, Hastings, TN35 4PL
Tel: [phone]
[email protected]
www/dolphindispensers.co.uk
Sensing Range Adjustment
These dryers are supplied with a factory set range, it is adjustable but where
possible it is better left at the factory setting.
If you want to modify the SENSING RANGE, please use the following
procedures:
With reference to the time assembly drawing below (fig 1.)
• Isolate the dryer from the power supply
• Remove the ENCLOSURE/HOUSING of the hand dryer
• Remove the outlet case of the TIMER ASSEMBLY
• Find the SENSING RANGE ADJUSTER inside the TIMER ASSEMBLY
• Use a small suitable screw driver to adjust the SENSING RANGE ADJUSTER
Clockwise to lengthen
the sensing range (+)
Anticlockwise to shorten the
sensing range (–)
BC 5262-102 and BC 2201
Figure 1