Dorel Asia BUNK BED WM3911-13 User manual

Model No.: UPC CODE: Color
WM3911-13 0-65857-15752-9 PINE
WM3921-13 0-65857-15700-0 LIGHT CHERRY
WM3921E2 0-65857-16529-6 MOCHA
WM3921B-DC 0-65857-16887-7 BLACK
WM3921W-DC-13 0-65857-16277-6 WHITE
WM3921G-DC 0-65857-16785-6 GREY
Lot number:
(TAKEN FROM CARTON)
NOTE:
DOREL ASIA
BUNK BED
_______ / _______ / _______
THIS INSTRUCTION BOOKLET
CONTAINS IMPORTANT SAFETY
KEEP FOR FUTURE REFERENCE.
INFORMATION. PLEASE READ AND
Date of purchase:
DONOT RETURN PRODUCT TO THE STORE.
If a part is missing or damaged, contact our customer service
department. We will replace the part FREE of charge.
Tel # : [phone]
E-Mail: [e-mail]
Fax #: [phone]

*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
ALWAYS USE THE RECOMMENDED SIZE MATTRESS OR MATTRESS SUPPORT, OR BOTH, TO
HELP PREVENT THE LIKELIHOOD OF ENTRAPMENT OR FALLS.
USE ONLY MATTRESSES WHICH ARE 74"-75" LONG AND 37 1/2" - 38 1/2" WIDE ON UPPER AND ON
LOWER BUNKS. ENSURE THICKNESS OF MATTRESS DOES NOT EXCEED 6". SURFACE OF
MATTRESS MUST BE AT LEAST 5" (127MM) BELOW THE UPPER EDGE OF GUARDRAILS.
DO NOT ALLOW CHILDREN UNDER 6 YEARS OF AGE TO USE THE UPPER BUNK.
ALWAYS USE THE LADDER FOR ENTERING AND LEAVING THE UPPER BUNK.
ALWAYS USE GUARDRAILS ON BOTH LONG SIDES OF THE UPPER BUNK. IF THE BUNK BED
WILL BE PLACED NEXT TO THE WALL, THE GUARDRAIL THAT RUNS THE FULL LENGTH OF THE
BED SHOULD BE PLACED AGAINST THE WALL TO PREVENT ENTRAPMENT BETWEEN THE BED
AND WALL (APPLICABLE FOR BUNK BEDS WITH FULL LENGTH GUARDRAILS ON ONE SIDE).
PERIODICALLY CHECK AND ENSURE THAT THE GUARDRAIL, LADDER AND OTHER
COMPONENTS ARE IN THEIR PROPER POSITION, FREE FROM DAMAGE, AND THAT ALL
CONNECTORS ARE TIGHT.
DO NOT ALLOW HORSEPLAY ON OR UNDER THE BED AND PROHIBIT JUMPING ON THE BED.
MAXIMUM WEIGHT CAPACITY: 165 LBS (75 KGS) PER LEVEL.
DO NOT USE SUBSTITUTE PARTS. CONTACT CUSTOMER SERVICE FOR REPLACEMENT PARTS.
USE OF A NIGHT LIGHT MAY PROVIDE ADDED SAFETY PRECAUTION FOR A CHILD USING THE
UPPER BUNK.
E-MAIL: [email protected]
WARNING
STRANGULATION HAZARD - NEVER ATTACH OR HANG ITEMS TO ANY PART OF THE BUNK
BED THAT ARE NOT DESIGNED FOR USE WITH THE BED; FOR EXAMPLE, BUT NOT LIMITED TO
HOOKS, BELTS AND JUMP ROPES.
FOLLOW THE INFORMATION ON THE WARNINGS APPEARING ON THE UPPER BUNK END
STRUCTURE AND ON THE CARTON. DO NOT REMOVE WARNING LABEL FROM BED.
PROHIBIT MORE THAN ONE PERSON ON UPPER BUNK.
KEEP THESE INSTRUCTIONS FOR FUTURE USE.
THE USE OF WATER OR SLEEP FLOTATION MATTRESSES IS PROHIBITED.
THE MATTRESS PLATFORM IS DESIGNED TO SUPPORT A MATTRESS WITHOUT THE NEED FOR A
POSTURE BOARD OR BOX SPRING.
USE ONLY COIL SPRING MATTRESSES ON BOTH THE UPPER AND LOWER BUNKS. FAILURE
TO DO SO CAN RESULT IN INJURY.
CUSTOMER SERVICE
If you are missing parts or have any questions about this product, contact our customer service representative
first!
CALL 1-800-295-1980
You can also order parts by writing to the address listed below. Please include the product model number,
color and a detailed description of the part.
Customer Service Department No. 413
12345 Albert-Hudon Boulevard, Suite 100
Montreal, Quebec
Canada, H1G 3L1

*
*
*
*
*
*
*
*
Check bolts/screws periodically and tighten them if necessary.
WARNING: Should this product become
damaged, and/or components are broken
or missing, DO NOT USE.
BED IS DESIGNED FOR CHILDREN RANGING FROM 6 YEARS OF AGE TO YOUNG TEENAGERS.
Dust regularly with a soft, dry cloth. We do not recommend the use of chemical cleaners or wax on our
lacquered furniture as it may damage the finish. Keep solvents, alcohol, nail polish and polish removers away
from your hardwood furniture surfaces.
MAINTENANCE
LIMITED WARRANTY
Dorel warrants its product to be free from defects in material and workmanship and agrees to remedy any such
defect. This warranty covers 1 year from the date of original purchase. This warranty is valid only upon
presentation of proof of purchase. This is solely limited to the repair or replacement of defective furniture
components and no assembly labor is included. This warranty does not apply to any product which has been
improperly assembled, subjected to misuse or abuse or which has been altered or repaired in any way. This
warranty gives you specific legal rights and you may also have other rights which vary from State to State.
CARE AND CLEANING
PHILLIPS SCREWDRIVER (NOT INCLUDED) IS REQUIRED.
A RUBBER MALLET (NOT INCLUDED) IS RECOMMENDED TO FACILITATE ASSEMBLY.
READ EACH STEP CAREFULLY BEFORE STARTING. IT IS VERY IMPORTANT THAT EACH STEP OF
INSTRUCTION IS PERFORMED IN THE CORRECT ORDER. IF THESE STEPS ARE NOT FOLLOWED IN
SEQUENCE, ASSEMBLY DIFFICULTIES WILL OCCUR AND CAN RESULT IN INJURY.
CAUTION: ADULT ASSEMBLY REQUIRED
ASSEMBLY WILL REQUIRE TWO PEOPLE.
MOST BOARD PARTS ARE LABELED OR STAMPED ON THE RAW EDGE.
MAKE SURE ALL PARTS ARE INCLUDED. WORK IN SPACIOUS AREA, PREFERABLY ON A
SMOOTH SOFT SURFACE.
NOTES

BUNK BED
ALLEN KEY

BUNK BED
E

BUNK BED

One of the headboard top crosses (F) has a label on it, do not use it in this step.
NOTES: Headboard top cross (F),headboard bottom cross (G), and headboard center cross (S) may require
that they be pulled closer together or further apart in order to allow wood dowels (7) to align with holes in top
posts (A and B).
BUNK BED
Insert wood dowels (7) into the ends of headboard top cross (F), headboard bottom cross (G), and headboard
center cross (S).
Attach top posts (A and B) using wood joint connectors (3) as shown.
STEP 1

STEP 2
BUNK BED
Repeat the previous step to assemble the remaining three sets of headboards. Be sure to pair the bottom
posts (D) and (E) for one pair; (E) and (D) for another; and the top posts (C) and (A) for the last pair.
NOTE: Be sure to use headboard top cross (F) with label attached to it between top posts (A) and (C). See
illustration for label orientation.

BUNK BED
Attach the two headboards with bottom posts (D and E) to bottom side rails (I and K) using joint connectors (1)
and barrel nuts (8) as shown.
Note: This is the lower bunk.
STEP 3
I
K
Holes
1
1
9
8
8
8
8
I
K
Holes
1
1
9
8
8
8
8

STEP 4
BUNK BED
Insert a wood dowel (7) into each end of the long guardrails (M). Attach two long guardrails (M) and two
top side rails (H and J) to top posts (A and B) & (A and C) as shown.
Fasten top side rails (H and J) with joint connectors (1) and barrel nuts (8). Fasten long guardrails (M)
with wood joint connectors (3) .
Use Allen key (9) to tighten all joint connectors.
This is the upper bunk.
3
M
3
M
3
M

STEP 5
BUNK BED
Insert two slats (T) into the center slots of the bottom side rails (I and K) of the bottom bunk as shown.
NOTE: Once inserted, there should be three empty spaces left on each side.

STEP 6
BUNK BED
Insert slat (L) into remaining holes on the bottom side rails (I and K) on the lower bunk.
Secure slats (L) to the bottom side rails (1 and K) with flat head wood screws (4) using a phillips head screw
driver (not included).
Repeat step 5 and 6 to attach slats (T and L) to the upper bunk.
NOTE: Slats (T and L) will be placed between two wooden blocks.
NOTE: If you notice that any slats (L) are not perfectly flat, be sure to assemble them so that slat (L) curves
up in the middle and down at the ends.

STEP 7
Insert wood dowels (7) in the ends of short guardrails (N). Attach short guardrails (N) to top post (A) with wood
joint connectors (3).
Attach the guardrail leg (R) to the short guardrails (N) and top side rail (H) with flat head wood screws (5).
Attach the other guardrail leg (R) to long guard rails (M) and top side rail (J) with flat head wood screws (5).
use a Phillips head screwdriver (not included) to install screws (5).
BUNK BED
Place four wood dowels (6) into the holes in the bottom posts (D and E). Stack the top bunk onto the bottom
bunk with the help of another person.
5
5
7
3
R
R
N
M
K
J
I
H
C
B
A
6
6
5
5
7
3
R
R
N
M
K
J
I
H
C
B
A
6
6
5
5
7
3
R
R
N
M
K
J
I
H
C
B
A
6
6

STEP 8
BUNK BED
To assemble the ladder, insert wood dowels (7) into the ends of the ladder steps (Q).
Attach long ladder end (O) and short ladder end (P) to ladder steps (Q) with wood joint
connectors (2) and Allen key (9).
8 PCS
2
78 PCS

STEP 9
BUNK BED
Attach the ladder to the short guardrails (N), top side rail (H) and bottom side rail (I) with
wood joint connectors (2) as shown.
NOTE: If slat (L) is covering the ladder mounting holes, remove slat (L) and replace after
the ladder is attached.
Slats are not shown
in illustration for
clarity
N
H
I
26PCS
2

With the help of another person, remove the top bunk from the lower bunk.
Note: Switching the headboards will allow the two single beds to be identical (the headboards will have
taller posts and the footboards will have the shorter posts).
CONVERTING THE BUNK BED INTO TWO SINGLE BEDS
Remove the ladder and all the guardrails.
Disassemble the side rails from all headboards (top and lower bunks).
Re-assemble the headboards (with tall posts) and footboards (with short posts) to side rails.

CAUTION: This unit is intended for use only with the products
and/or maximum weights indicated. Use with other products and/or
products heavier than the maximum weights indicated may result in
instability or cause possible injury.
BUNK BED
USE ONLY COIL SPRING
MATTRESSES ON BOTH THE
UPPER AND LOWER BUNKS.
FAILURE TO DO SO CAN
RESULT IN INJURY.
USE ONLY MATTRESSES
WHICH ARE 74"-75" LONG AND
37 1/2" - 38 1/2" WIDE ON UPPER
AND ON LOWER BUNKS.
ENSURE THICKNESS OF
MATTRESS DOES NOT EXCEED
6".
DO NOT ALLOW CHILDREN
UNDER 6 YEARS OF AGE TO USE
THE UPPER BUNK. BED IS
DESIGNED FOR CHILDREN
RANGING FROM 6 YEARS OF
AGE TO YOUNG TEENAGERS.
DO NOT ALLOW HORSEPLAY
ON OR UNDER THE BED AND
PROHIBIT JUMPING ON THE
BED.
MAXIMUM WEIGHT
CAPACITY: 165 LBS
(75 KGS) PER LEVEL.
DO NOT RETURN PRODUCT TO THE STORE.
If a part is missing or damaged, contact our customer service
department. We will replace the part FREEof charge.
Tel # : [phone]
E-Mail: [e-mail]
Fax #: [phone]