Dräger Medical Fabius Tiro Manual

Service
Procedure
Field
Date: 18 November 2003
© 2003 Draeger Medical, Inc.
Part Number: SP00277
Rev: A
Flip Up Tray Installation on Fabius Tiro™
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

SP00277
10/6/03
1
Flip-up Tray Mounting Instructions
Purpose: The purpose of this document is to provide instruction for the installation and operation of the
Flip-up Tray.
Parts Reference
The following parts and hardware are included with this installation kit.
INSTALLATION PROCEDURE:
1. Remove the two M8 socket head cap screws (item 1), two spacers (item 2), and Draeger rail
(item 3) from the side of the trolley (Figure 1).
Figure 1. Remove Draeger Rail
Item# Description Qty
1Flip up tray
1
2GCX handle 1
3Resuscitatormounting hook 1
4#10 self tapping screw 2
55/32”Tension wrench 1
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

SP00277
10/6/03
2
2. Insert the Flip-up Tray slide (item 1)in the GCX channel (Figure 2).
3. Move the Flip-up Tray to the desired height and tighten the two clamping screws (item 2) on slide
bottom to secure the Flip-up Tray in the channel (Figure 2).
Figure 2. Attach Flip-up Tray
4. Insert the handle (item 1) in the GCX channel (item 2) as shown in Figure 3.
5. Route the hoses (item 3) under the handle, then adjust handle until handle rests on top surface of
trolley (Figure 3).
6. Tighten set screws (item 4) on the handle with wrench provided.
Figure 3. Hose routing and handle attachment
(2)
(4)
(1)
(3)
(1)
(2)
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

SP00277
10/6/03
3
7. Attach resuscitator hook (item 1) to back of Fabius Tiro using two #10 self tapping screws (item 2)
provided (Figure 4).
Figure 4. Attach resuscitator hook
(2)
(1)
Rear of trolley
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

SP00277
10/6/03
4
OPERATION OF FLIP UP TRAY:
1. To open tray, lift tray until it locks in position (locking is identified when click is heard).
2. To release tray, pull the tray handle (item 1) forward (Figure 5).
Figure 5. Tray in extended position
Figure 6. Tray in folded position
Direction
of pull.
(1)
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS

DrägerService is a division of
Draeger Medical, Inc.
3122 Commerce Drive
Telford, PA 18969
Tel: [phone]
[phone]
Fax:[phone]
Web: www.draegermedical.com
Printed in the U.S.A.
RETURN TO CD-ROM TABLE OF CONTENTS
RETURN TO SERVICE PROCEDURE TABLE OF CONTENTS