Drive Medical 12203kd4 User manual

deluxe bath bench
www.drivemedical.com
EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

1. Remove contents from box.
2. Lay seat upside down on a flat surface so the 4 leg
receptacles are facing upward.
3. Insert first leg into the leg receptacle by depressing
push pin. When the leg is in place, the brass push
pin will extend out and lock the leg in place
(Figure 1).
4. Repeat Step 3 for the remaining 3 legs.
assembly instructions
adjusting leg height
1. Before use, adjust height of each
leg to your specific needs, making
sure all legs are at the same height.
When desired height is reached,
lock legs into place by aligning
buttons into proper holes, per
illustration.
2. To be sure legs are locked into
place by pushing down on or by
pulling legs.
 Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO
NOT USE. Contact dealer/carrier for further
instructions.
 Make certain that the height adjusting snap
buttons fully protrude through the same
respective hole of each leg extension. This
will ensure that the leg extensions are
securely locked in position and an even height
is achieved.
 Ensure ALL screws, nuts and/or bolts are
tightened.
 Check the rubber tips on the leg extensions
for rips, wear or if they are missing.
Immediately replace any or all if any of these
imperfections exist.
 All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
6. DO NOT stand on chair.
additional precautions
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water. Wipe
bath seat dry after each use.
figure 1
WEIGHT CAPACITY: 350 LBS.