Drive cruiser III User manual

cruiser lll wheelchair
EU Authorized Representative
Drive Medical LTD
Ainley's Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
www.drivemedical.com
Rev5.08.09.18

handgrip back upholstery
æ<—— armrest
rear
wheel
side
panel
handrim
front rigging
>
wheel lock
caster wheel fork foot plate
CAUTION:
Stability - Wheelchair is designed to be safe and stable
as long as center of gravity is maintained while going
about normal activities. Care must be taken while
performing activities that shift your center of gravity in
the chair. Never reach so far that require you to shift in
the seat or bend over out of the chair. When you have
to reach for objects that require you to lean, be certain
front casters are pointing in a forward position that
extends the wheel base and will stabilize the chair.
Ramps - Be sure of your own capabilities, limitations and
strength before attempting to go up a ramp. Correct
techniques on ramp negotiation should be shown to you
by a qualified professional. Assistance is recommended
when going up or down inclines greater than 10°. If you
must stop on an incline, avoid sudden, abrupt movement
when you resume movement. Because of backward
angle of the chair, sudden abrupt movement could cause
instability. Attempting to use the wheel lock brakes
could result in accidental locking, tipping to one side,
or cause a sudden stop. Avoid changing direction when
going down an incline, as this could result in instability
of tipping over.

Please read this manual carefully to insure safe usage
and understanding of maintenance instructions.
Congratulations on your purchase of a Drive wheel-
chair. Drive wheelchairs are a product of quality
engineering and are manufactured to meet our own
highly rigid specifications and will surpass all your
e expectations.
| Use and Safety
WHEEL LOCKS - Engage both wheel locks before
getting in or out of chair, leaning forward in chair, or
while in an elevator or wheelchair lift. Proper adjust-
ment of wheel lock is at least 1/8” when locked.
Locks are engaged by pushing handle completely
forward. Adjustments to locks are made by loosen-
ing or tightening nut on the carriage bolt. Embed
lock shoe at least 1/8” by sliding clamp toward rear
wheel while handle is engaged in locked position.
Tighten nut and bolt to secure in position. Test for
correct locking action before actual use.
TIRES - Solid rubber tires need minimal mainte-
nance, but should be cleaned occasionally with a
damp cloth. Replace if tires become severely worn
or cracking appears.
FRONT CASTERS - Casters should be checked
periodically and lubricated occasionally. Lubricate
by removing fork and greasing caster stem bearings.
Lubricate wheel bearings by removing wheel from
fork. Reassemble fork and wheel by tightening nuts
until no play remains, but wheels roll freely. If nut is
too loose, caster will shimmy, if too tight, chair will
be hard to steer.

TO CLOSE/FOLD CHAIR - First fold foot plates
to vertical position. Grab seat with both hands
at front and back edge and lift. Or, tilt chair to
one side and lift up on seat rail.
REMOVABLE ARMS - Remove arms by depress-
ing spring button and lifting arms out of front
and rear sockets.
WARNING
Do not attempt to adjust or operate wheelchair
without reading carefully all instructions in this
manual.
This wheelchair has not been approved as a
seat that can be used within vehicles of any
kind. Always transfer wheelchair user to a
vehicle manufacturers approved seat and use
safety restraints available.
Do not operate this wheelchair on roadways,
streets or any surfaces with vehicular traffic.
Do not attempt to operate on inclines 10° or
greater without proper assistance.
Be sure to completely engage wheel locks
when getting in and out of wheelchair or when
in elevator or wheelchair lift.
Wheelchair should be on a smooth, stable and
level area with wheel locks engaged before
transferring user in or out of wheelchair.
Do not adjust foot rests any lower than 2-1/2”
from floor.
When getting in or out of wheelchair, do not
stand on or apply weight to foot rests.
Before reaching or leaning forward, rotate cast-
ers to front of the wheelchair engage wheel
locks to help prevent wheelchair from tipping
over.

seat extension
instructions
Your Cruiser Ill Wheelchair comes with an adjustable depth
seat that has been factory set at the shortest position.
Follow the instructions below to extend the seat depth of
your chair.
Fa ef
. Lay wheelchair on its back. Open seat two-thirds of
the way so seat posts do NOT rest on chair frame.
Unfold seat extension by pulling upward on end of
seat to release the hook and loop fastener.
—
ee H
2. Pull outward on hook and loop strips to free them
from underside of seat.
Cr
3. The seat extension post is located inside the seat
frame. To access it, turn screw counter-clockwise and
remove it.

lifetime limited
warranty
Your Drive branded product is warrantied to be free of
defects in materials and workmanship for the lifetime of
the product for the original consumer purchaser.
This device was built to exacting standards and care-
fully inspected prior to shipment. This Lifetime Limited
Warranty is an expression of our confidence in the mate-
rials and workmanship of our products and our assur-
ance to the consumer of years of dependable service.
This warranty does not cover device failure due to owner
misuse or negligence, or normal wear and tear. The
warranty does not extend to non-durable components,
such as rubber accessories, casters, and grips, which are
subject to normal wear and need periodic replacement.
If you have a question about your Drive device or this
warranty, please contact an authorized Drive dealer.
iA. WARNING: This products Bates
including Styrene, which is known to the State of
California to cause cancer. For more information go to
www.P65Warnings.ca.gov.
drive
© 2018 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

www.drivemedical.com

www.drivemedical.com

cruiser Ill wheelchair
EU Authorized Representative
Drive Medical LTD
Ainley's Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP
www.drivemedical.com
Rev5.08.09.18