DT Research DT301NV Assembly instructions

Rugged Tablet
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
Copyright © 2020, DT Research, Inc. All Rights Reserved. BOG022520 DT301NV ENG
INTRODUCTION
Thank you for acquiring the DT301NV, part of DT Research’s line of Rugged tablets.
Featuring a slim yet robust enclosure, the DT301NV with 10.1” and dual mode
switchable NVIS or high-brightness touchscreen is powered by the Intel® processor,
oering opmal combinaons of performance and power savings. The DT301NV is
available with Microso® Windows® operang system and features web browser,
client/ server compung soware, media player, accessories, and applicaons
support.
PACKAGE CONTENTS
• One DT301NV with Baery Pack and Handstrap
• AC-DC Power Adapter with Power Cord
• Basic Operaon Guide
* If your DT301NV contains camera or barcode scanner, please refer to the Tablet
Modules Basic Operaon Guide for detailed operaon.
DT301NV
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protecon against harmful interference in
a residenal installaon. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or
television recepon, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in
conjuncon with any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.

Button Functions
BUTTON ACTION BUTTON ACTION
Power Buon Control Center Buon
Windows Key Buon NVIS/ Normal Mode Toggle
Programmable Buons Brightness Control Buons
Baery Latch *Push the switch up
to unlock the latch, then slide the latch
le to remove the baery.
Input/ Output Ports
Headphone Jack
LAN Port
USB 3.0 Port
USB Type-C Port
(also as power input)
Smart Card Reader
1 2
3
5
4
6
7
A
B
C
E
D
2
Baery/Power LED
Sleep Mode LED
5
7
1
E
A
C
D
B
2 3 4 6
3
PRECAUTIONS
• Always exercise care when operang and handling the DT301NV.
• Do NOT apply excessive pressure to the display screen.
• We recommend using the Digital Pen (oponal) to keep the screen clean.
• Avoid prolonged exposure of the display panel to any strong heat source.
Wherever possible, the DT301NV should face away from direct light to reduce
glare.
• If the AC-DC power adapter is used to recharge or power the tablet, do NOT
use any AC-DC adapter other than the one provided or acquired from the
manufacturer or its partners.
• In the unlikely event that smoke, abnormal noise, or strange odor is present,
immediately power o the DT301NV and disconnect all power sources. Report
the problem to your device provider immediately.
• Never aempt to disassemble the DT301NV, as this will void the warranty.
BASIC FEATURES
The DT301NV rugged tablet integrates a dual mode switchable NVIS or high-brightness
touchscreen, USB ports, and embedded networking elements such as wireless LAN and
Bluetooth or oponal 4G LTE/ AWS.
A DT301NV typically integrates an 802.11ac wireless LAN (WLAN) adapter that may
connect to other wireless devices or access points. If your DT301NV does not come
with such a network adapter, please consult your device provider to establish the
desired network connecvity.
NOTE:
To obtain protecon consistent with any IP rang for the device, the I/O (audio,
power, USB, card reader, etc.) port doors must be closed. If the IP protecon is
compromised by mishandling or misuse, such as by leaving port doors open or
improperly closed, any resulng product damage will not be covered under any
DT Research warranty.

OPERATION
Powering ON and OFF
To acvate the DT301NV, push and quickly release the Power Buon. The display will
come on in a few seconds. To put the DT301NV in Standby mode, push and quickly
release the Power Buon. To turn the DT301NV o for extended storage, power
o safely using any soware funcon that “shuts down computer” provided in the
soware operang system.
NOTE:
The baery pack shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT301NV when seng up for the rst me to fully
charge the baery pack, or use the oponal baery charger kit.
NOTE:
When the baery pack is charging, the blue Baery LED should blink slowly.
If plugging in the AC-DC adapter does not trigger this blinking acvity and
the LED stays dark, the baery pack(s) may have been drained substanally.
Try unplugging/ replugging the AC-DC adapter to the DT301NY a few mes to
acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby” mode while not in use. Pushing briey on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (“hold 4+ seconds” feature) to turn o the
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
4
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed aer a launch sequence of several seconds. The wireless
LAN connecon may take 10-15 seconds to be established.
Configuring the Rugged Tablet
The DT301NV may be congured using the ulies and methods dictated by
the soware operang system. The DT301NV should be congurable for various
properes such as user proles, network features, and several system elements.
NVIS Mode and Screen Brightness Control
• When power buon is pressed to power on the unit, power LED will ash orange
once to indicate the unit is boong. Unit will boot into NVIS mode with zero nit
brightness by default and display will be dark. You can press the “Brightness Up”
and “Brightness Down” buons to set NVIS mode display to desired brightness
(up to 20 nits).
• To toggle between NVIS and high-brightness display mode, press the “NVIS/
Normal Mode Toggle” buon. When changed from NVIS mode to high-brightness
mode, display brightness percentage will be same as the brightness level set in
NVIS mode before toggling.
• Use brightness control buons to set desired brightness level. When changed
from normal display mode to NVIS mode, display brightness will be set to 0 nit
(display is dark) and you need to use brightness control buons to change display
to desired brightness.
• Brightness up, Brightness down, NVIS/Normal toggle, Windows Key and Control
Center funcons are xed and not user programmable.
• Two programmable buons on le side can be programmed through Buon
Manager.
5

6
Wireless Networking
Wireless LAN
The DT301NV is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
• Through the support of typical WLAN adapters, the DT301NV should be able to
detect all 802.11 access points in the vicinity to select the access point of choice
for connecon.
• The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT301NV and the
access points have to match. The SSID is case-sensive and it is recommended to
enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for secure access.
• When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
• Refer to the access point operang manuals for seng up the 802.11 access
points.
Bluetooth
The Bluetooth conguraon applicaon is enabled from the System Tray or from the
Windows Mobility Center. Follow the instrucons and opons provided within the
applicaon to congure and invoke Bluetooth connecvity with the corresponding
peripherals.
7
USING THE RUGGED TABLET
Peripherals Support
Through its USB 3.0 port, the DT301NV supports a wide range of USB-based
peripherals. These peripherals are applicable for soware installaon, applicaons
storage, data storage, and system soware recovery and updates.
For More Support
Users can download the Tablet Modules Basic Operaon Guides from the DT Research
website.
If the DT301NV comes with a Mobile broadband module, please contact your
product and/or service provider for the SIM Card installaon procedures.
To Hold the Tablet
Le hand: grip the le back side of the tablet
with your le hand four index ngers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.
Right hand: grip the right back side of the tablet
with your right hand four index ngers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.