DT Research DT311C Assembly instructions

DT311C/ DT311H
Rugged Tablet
ENGLISH 8
signage dtri com
DT Research, Inc.
2000 Concourse Drive, San Jose, CA 95131
Copyright © 2017, DT Research, Inc. All Rights Reserved.
BOG032817DT311CHENG
Federal Communicaon Commission Interference
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instrucons, may
cause harmful interference to radio communicaons. However, there is no
guarantee that interference will not occur in a parcular installaon. If this
equipment does cause harmful interference to radio or television recepon,
which can be determined by turning the equipment offand on, the user is
encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separaon between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which•
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.•
FCC Cauon: Any changes or modificaons not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules.
Operaon is subject to the following two condions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operaon.
This device and its antenna(s) must not be co-located or operang in conjuncon
with any other antenna or transmier.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
INTRODUCTION
Thank you for acquiring the latest addion to DT Research’s line of tablets —the
DT311C/ DT311H. Featuring a slim yet robust enclosure, the DT311C/ DT311H with
11.6”TFT display is powered by the Intel® processor, offering opmal combinaons
of performance and power savings. The DT311C/ DT311H is available with Microso®
Windows® operang systems. Each soware operang system features web browser,
client/ server compung soware, media player, accessories, and applicaons support.
PACKAGE CONTENTS
One•DT311C/ DT311H with Baery Pack and Handstrap
AC-DC Power Adapter with Power Cord•
Basic Operaon Guide•
Major opons, depending on configuraon:
Desktop Charging Cradle with DC-in Power Jack and Ethernet and USB Ports•
Wall/ Vehicle Mount Cradle with DC-in Power Jack and Ethernet and USB Ports•
Detachable Keyboard; connects automacally without switching and pairing,•
ideal for 2-in-1 applicaons

DT311C/ DT311H
Buon Funcons
BUTTON ACTION
Programmable buon
Power buon
RF switch
Baery Latch •Push the switch up to unlock the latch, then slide the latch leto remove the baery.
Input/ Output Ports
USB 3.0 Port
Headphone Jack
DC Power Input
Smart Card Reader
Back Camera (oponal)
The DT311C/ DT311H
1
2
3
4
A
B
C
Baery/Power LED 2
3
4
1
E
D
D
E
A
C
B
ENGLISH 23ENGLISH
Power/Baery LED Status:
Blue indicates the baery is 25% to 100% charged•
Blinking blue indicates the baery is charging•
Orange indicates that the baery is between 11% to 25%•
Blinking Orange indicates that the baery is below 10%•
Precauons
Always exercise care when operang and handling the
•DT311C/ DT311H.
Do NOT apply excessive pressure to the display screen.
•
We recommend using the Digital Pen (oponal) to keep the screen clean.
•
A
•void prolonged exposure of the display panel to any strong heat source. Wherever
possible, the DT311C/ DT311H should face away from direct light to reduce glare.
If the AC-DC power adapter is used to recharge or power the tablet, do NOT use any
•
AC-DC adapter other than the one provided or acquired from the manufacturer or its
partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present,
•
immediately power offthe DT311C/ DT311H and disconnect all power sources. Report
the problem to your device provider immediately.
Never aempt to disassemble the
•DT311C/ DT311H, as this will void the warranty.
THE DT311C/ DT311H
Basic Features
The DT311C/ DT311H wireless tablet integrates a bright display, one USB port, and
embedded networking elements such as wireless LAN and Bluetooth or oponal
3G/ 4G. The DT311C/ DT311H is complemented by a suite of accessories, including
baery expansion, charging cradles, and baery charger kit, for a comprehensive user
experience.
A DT311C/ DT311H typically integrates an 802.11ac wireless LAN (WLAN) adapter that
may connect to other wireless devices or access points. If your DT311C/ DT311H does not
come with such a network adapter, please consult your device provider to establish the
desired network connecvity.

DT311C/ DT311H
ENGLISH 4
OPERATION
Powering ON and OFF
To acvate the DT311C/ DT311H, push and quickly release the Power Buon. The display
will come on in a few seconds. To put the DT311C/ DT311H in Standby mode, push and
quickly release the Power Buon. To turn the DT311C/ DT311H offfor extended storage,
power offsafely using any soware funcon that “shuts down computer”provided in the
soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power—please use the
AC-DC adapter with the DT311C/ DT311H when seng up for the first me to
fully charge the internal baery pack. You may charge the external baery pack
with it aached to the DT311C/ DT311H, or with the oponal external baery
charger kit.
NOTE:
When the baery pack(s) is (are) charging, the blue-colored Baery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
acvity and the LED stays dark, the baery pack(s) may have been drained
substanally. Try unplugging/ replugging the AC-DC adapter to the DT311C/
DT311H a few mes to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby”mode while not in use. Pushing briefly on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (“hold 4+ seconds”feature) to turn offthe
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
5ENGLISH
Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate interface
will be displayed aer a launch sequence of several seconds. The wireless LAN connecon
may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT311C/ DT311H may be configured using the ulies and methods dictated by
the soware operang system. The DT311C/ DT311H should be configurable for various
properes such as user profiles, network features, and several system elements.
Wireless Networking
Wireless LAN
The DT311C/ DT311H is oen delivered with an embedded (user-inaccessible) 802.11ac
WLAN adapter equipped with a hidden custom antenna.
T
•hrough the support of typical WLAN adapters, the DT311C/ DT311H should be able
to detect all 802.11 access points in the vicinity for you to select the access point of
your choice for connecon.
T
•he SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT311C/ DT311H and
the access points have to match. The SSID is case-sensive and it is recommended
that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves) for secure
access.
W
•hen WEP/WPA/WPA2 is enabled, you may need to consult your network admin-
istrator or your networking equipment literature to properly configure associated
sengs such as Authencaon mode, etc.
R
•efer to the access point operang manuals for seng up the 802.11 access points.

DT311C/ DT311H
ENGLISH 6
Bluetooth
The Bluetooth configuraon applicaon is enabled from the System Tray or from the
Windows Mobility Center. Follow the instrucons and opons provided within the appli-
caon to configure and invoke Bluetooth connecvity with the corresponding peripherals.
Desktop Cradle
The DT311C/ DT311H is complemented by an oponal Desktop Cradle for support, pass-
through charging, and connecon to a range of USB peripherals, including keyboard and
mouse. The Cradle offers the following interfaces: a DC-in port for the AC-DC adapter, an
Ethernet port and USB ports. Always seat the DT311C/ DT311H securely onto the cradle.
The cradle must be powered by the AC-DC adapter for the Ethernet and USB ports to
funcon. The baery packs on the DT311C/ DT311H may be recharged by connecng the
AC-DC adapter directly to the DC-in port on the DT311C/ DT311H or through the DC-in
port on the Desktop Cradle while the DT311C/ DT311H is docked to the Cradle.
USING THE Mobile Tablet
Peripherals Support
Through its USB 3.0 port, the DT311C/ DT311H supports a wide range of USB-based
peripherals. These peripherals are applicable for soware installaon, applicaons
storage, data storage, and system soware recovery and updates. The DT311C/
DT311H is also compable with custom mountable cradle opons. These securable and
mountable cradles provide an interface to VESA mounts and arms, and to ports that may
include USB, Ethernet, and pass-through power.
Remote Management
Depending on soware configuraon, the DT311C/ DT311H can be centrally managed for
asset monitoring and for soware control. Please consult your device provider.
For More Support
Users can download the Tablet Modules Basic Operaon Guides from the DT Research
website.
If the DT311C/ DT311H comes with a 3G/ 4G module, please contact your product and/or
service provider for the SIM Card installaon procedures.
7ENGLISH
To Hold the Tablet
Lehand: grip the leback side of the tablet
with your lehand four index fingers, with thumb
resng on the top of the back side of the tablet
and palm securely against the back.
Right hand: grip the right back side of the tablet
with your right hand four index fingers, with
thumb resng on the top of the back side of the
tablet and palm securely against the back.
ENERGY STAR® Partner
As an ENERGY STAR® Partner, DT Research Inc. follows the EPA’s product
qualificaon and cerficaon process to ensure the products marked with the
ENERGY STAR® logo are ENERGY STAR® qualified for energy efficiency.
The ENERGY STAR® program specificaons for computers were to promote energy
efficiency and reduce air polluon through more energy-efficient equipment in
homes, offices, and factories. One way products achieve this goal is by using the
MicrosoWindows power management feature to reduce power consumpon
when the product is not in use. The power management feature enables the
computer to iniate a low-power or “sleep”mode aer a period of user inacvity.
To take advantage of these potenal energy savings, users should use the default
power management sengs that are provided with ENERGY STAR qualified
computers. The default power management sengs on ENERGY STAR® qualified
computers are preset to behave in the following ways :
Turn offdisplay aer 10 minutes of user inacvity.•
Iniate a low power sleep mode for the computer aer 30 minutes of user•
inacvity.
Briefly press the power buon will bring the computer out of sleep mode.•
Addional informaon on the ENERGY STAR® program, its environmental benefits
and the potenal energy and financial savings of the power management feature
can be found on the EPA ENERGY STAR® Power Management Web site at
hp://www.energystar.gov/powermanagement.