Duke FORM BWLAM END BREAD FS User manual

Installation Manual
Bread Laminate Kits:
FORM BWLAM END BREAD FS
FORM BWLAM END BREAD ADA FS
This manual is Copyright © 2018 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
P/N 529111
REV A 07/26/18
CAUTION: Please read this manual completely before attempting
to install, operate or service this equipment
Parts In Kit
One (1) Piece of Laminate
One (1) Bottom Trim Piece
Two (2) Side Trim Pieces
Four (4) Screw, 10-24 X 3/8” PTHMS
Three (3) Screw #10 X 1/2” HWH TEK
One (1) #21 Drill Bit
Tools Needed
Phillips Screwdriver
Cordless Drill
5/16”Wrench

Installation and Operation of: Bread Laminate Kit
Duke Manufacturing Co.
2305 N. Broadway
St. Louis, MO 63102
Phone: [phone]
Toll Free: 1-800-735-3853
Fax: [phone] www.dukemfg.com
ASSEMBLY
Remove Gromets





Using the three (3) #10 X 1/2”TEK
Screws, Secure the bottom trim to
unit.
NOTE: Holes located on underside
of unit.
Slide Laminate Panel in
from back of unit.
Using the #21 Drill Bit
(included with kit) and side
trim, mark and drill the
holes for the side trim.
Using the four (4) 10-24
X 3/8” Screws. Secure the
side trim to the unit.