Duke 2505249 User manual

This manual is Copyright © 2021 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
CAUTION: Please read these instructions completely before attempting
to install, operate or service this equipment.
WARNING for CA residents: go to www.dukemfg.com/prop65 for prop 65 warning
Instruction Sheet
POS Support Bracket Kit
2505249
P/N 229403
REV A 04/28/2021
PARTS IN KIT TOOLS NEEDED
Stubby Phillips Screw Driver
POS Support Bracket
2505248

2
Installation and Operation of: POS Bracket Installation
POS SUPPORT BRACKET INSTALLATION
1Start by disconnecting all electrical equipment located on top of the POS arm and set it aside in a
safe location.
Failure to disconnect power to equipment could cause equipment damage and or bodily injury.
2Remove the screws that are holding the POS arm in place, which are located underneath the
countertop. Do NOT discard these screws as they will be used in a later step.
Pull the POS arm out of the counter and pull all wires out of the bottom of the arm. Remove
and discard the rectangular cover plate that goes around the POS arm and rests on top of the
countertop.
3

3
Installation and Operation of: POS Bracket Installation
POS SUPPORT BRACKET INSTALLATION
Re-route all wires back through the POS arm that were removed in the earlier steps.
5
6
Remove the two screws at the bottom of the POS arm. Slide the retrot support bracket over the arm
until the two holes on the bracket line up with these two holes on the POS arms. Once the holes are
aligned, re-install the screws.
Do NOT fully tighten the screws as they will be tightened on a later step.
4
Slide the POS arm down into the hole of the countertop until the bracket rests ush against the top
of the countertop.
Note: This bracket is designed to t tight inside the hole of the countertop so the downward facing
anges of the bracket may need to be pressed inwards to allow them to clear the edge of the hole in
the countertop during installation.

Installation and Operation of: POS Bracket Installation
Duke Manufacturing Co.
2305 N. Broadway
St. Louis, MO 63102
Phone: [phone]
Toll Free: 1-800-735-3853
Fax: [phone] www.dukemfg.com
POS SUPPORT BRACKET INSTALLATION
7
8 9
10
Align the holes of the POS arm and the mounting bracket located underneath the countertop. Once
aligned, re-install and tighten the screws that were removed from step two, making sure not to
cross-thread them.
Tighten the screws that were left loose in step
four.
Place all equipment back on top of POS arm
and re-connect all wires to their designated
equipment.
Installation complete.