Duke DK-FRY-27-S-DQ User manual

PM Manual
Crispy Station
DKFRY27SDQ
DKFRY27DDQ
DKFRY36SDQ
DKFRY36DDQ
523086
REV E 05/05/2023
This manual is Copyright © 2020 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
CAUTION: Please read this manual completely before attempting
to install, operate or service this equipment
WARNING: Cancer and Reproductive Harm -
www.p65warnings.ca.gov

2
Installation and Operation of: Duke Crispy Station
CLEANING
Daily:
Do not use any highly caustic cleaners, acids or ammonia.
These may cause corrosion and/or damage to the stainless steel.
WARNING
General Cleaning Instructions
1. Turn Unit o and allow to cool.
2. Always clean equipment thoroughly before rst use. Clean unit daily, use warm, soapy
water or mild detergent.
3. Remove and clean: Fry Basket, Crumb Tray, Dividers and Small-ware Trough.
4. Wipe down all metal surfaces with a water-dampened, non-abrasive cloth.
• Stubborn stains may be removed using a good stainless steel or non-abrasive cleaner.
• Clean hard to reach areas using a small brush and mild soap.
NOTICE: DO NOT USE STEEL WOOL.
Remove from Basket
Slide Out Pull up and Out
1
2
34
Electrical shock hazard. Do not wash with water jet or hose.
CAUTION
Lift up and Out

3
Installation and Operation of: Duke Crispy Station
PREVENTIVE MAINTENANCE
REPLACING DISPLAY LIGHT BULBS
Use only light bulbs that meet or exceed National Sanitation Foundation (NSF) standards and are
specically designed for holding areas. Breakage of light bulbs not specially coated could result in
personal injury and or food contamination.
The display light is an incandescent bulb that illuminates the warming area. These bulbs have
a special coating to guard against injury and food contamination in the event of breakage.
To replace a display light bulb:
1. Disconnect the power supply and wait until unit has cooled.
2. Unscrew the light bulb from the unit and replace it with a new, specially-coated
incandescent or optional halogen bulb.
NOTE: Hatco shatter-resistant light bulbs meet NSF standards for food holding and display.
• For 120, 120/208, and 120/240 volt appliances use Hatco P/N 02.30.043.00.
Weekly:
1
2Using a soft cloth remove any oil or
debris from top of heater.
Lift grill up and out to remove for
cleaning.
CLEANING - continued
Follow the cleaning procedures in the cleaning section to avoid maintenance issues.
3Re-install top grill cover.
Failure to complete this step could result in
bodily injury

Installation and Operation of: Duke Crispy Station
Duke Manufacturing Co.
2305 N. Broadway
St. Louis, MO 63102
Phone: [phone]
Toll Free: 1-800-735-3853
Fax: [phone] www.dukemfg.com