1. Introduction
Thank you for purchasing the DURACELL Instant Power Charger. This is a 5 volt universal battery used to
power and charge many USB-powered electronic device such as cellular phones, PDAs, portable game
players, MP3 players and many more.
The Instant Power Charger is shipped in a discharged state and must be fully charged before initial use. Please
read the instructions below to properly charge and use the DURACELL Instant Power Charger.
2. Package Includes:
• USB to mini-USB cable
• DURACELL Instant Power Charger
3. Charging the Instant Power Charger
The Instant Power Charger is shipped in a discharged state. It must
be fully charged before initial use.
2
2
1
1
Charge Light
“ IN” Port
Status Light
“ OUT” Port
ON/OFF Switch
3.2:
Connect the cable’ s other end to a
laptop or other USB 2.0 charging
port
3.1:
Connecting the USB to mini-USB
cable to the “ IN” Port of the Instant
Power Charger
3.3 - 3.4:
A red light here on the Instant Power
Charger indicates that the Instant
Power Charger is being charged.
When the battery is fully charged,
this light becomes green.
Product Diagram
3.1. Connect the USB to mini-USB cable to the “IN” port of the
Instant Power Charger.
3.2. Connect the other end of the cable to your laptop’ s
USB port or any other USB 2.0 compatible port.
3.3. The Instant Power Charger’s charge light will turn red,
indicating battery is being charged.
3.4. When the charger is fully charged the charge light will turn
green. Disconnect the Instant Power Charger from the
USB cable. The charger is now ready for use.
4. Using the Instant Power Charger
4.1. Make sure the Instant Power Charger is charged prior to use (see
Section 3, Charging the Instant Power Charger, for instructions on how
to charge).
4.2. Connect a USB cable compatible with your device to the “OUT” port of
the Instant Power Charger. Device-specific USB cables are not included
but are readily available at most electronics stores. The USB to mini-USB
cable included in the package is compatible with many Motorola and
Blackberry phones.
Please note: most newer Motorola and Blackberry phones will not
charge using standard USB cables. For these phones please make sure
to use the included USB to mini-USB cable.
4.3. Connect the other end of the USB cable to your device.
4.4. Turn the Instant Power Charger switch to the “ON” position.
4.5. The LED status light will turn green, indicating that the charger is powering and charging your device. The
LED status light will turn red when the charger has been depleted and needs to be recharged.
4.6. When the Instant Power Charger is not in use, make sure to turn the switch to the “OFF” position. This
will prevent the charger from self-discharging.
5. Specifications
6. Safety Precautions
This charger is designed and built to the highest safety standards and will protect the user from hazards
when used as directed. Abuse of the charger may cause the battery to overheat or catch fire. Therefore, it
is important for users to read and follow these safety precautions.
• Do not disassemble.
• Always store in a cool dry place.
• Do not short-circuit.
• Use only with USB-powered devices.
• Only charge the battery from a USB 2.0 compatible port.
• Avoid placing in direct sunlight, next to heat-sensitive materials or in places where extreme heat may
result.
• Do not submerge or expose to water or liquids.
7. Warranty
If not completely satisfied with this charger, call 1-800-842-2127 (7:30 AM – 4:30 PM PST). Battery-Biz
guarantees this product against defects in materials and workmanship under normal use and service for three
years from the initial date of purchase. Should any device be damaged due to a charger defect, Battery-Biz
will repair or replace at our option if it is sent with the charger, postage prepaid to: Battery-Biz Inc., 1380
Flynn Rd, Camarillo, CA 93012; Attn: Consumer Dept.
Output Voltage 5 Volts DC
Input Voltage 5 Volts DC, 1 Amp maximum
4.2:
Connecting Standard USB Cable
4.4:
This is the status light that will glow when the
Instant Power Charger is charging and/or
powering your device.