dynarex Bari+Max 10374 User manual

Your Dynarex Product is warrantied to be free of defects in
materials and workmanship for the lifetime of the product for
the original purchaser. This item was built to exacting standards
and carefully inspected prior to shipment. This Limited Lifetime
Warranty is an expression of our confidence in the materials
and workmanship of our products and our assurance to the
consumer of years of dependable service.
The Warranty shall not apply under the following conditions:
• Problems arising from normal wear
• Problems arising from failure to adhere to the product
instructions
• Problems arising from misuse, negligence, accident or
improper operation, maintenance or storage
• Problems arising from modifications or unauthorized repairs,
parts or attachments
• Products where the serial number has been removed or
defaced
• Problems with non-durable components, such as rubber
accessories, casters, and grips, which are subject to normal
wear and need periodic replacement
Dynarex shall not be liable for any consequential or incidental
damages whatsoever. Dynarex shall repair or replace defective
products at its option. The foregoing warranty is exclusive and
in lieu of other express warranties, if any, including the implied
warranties of merchantability and fitness of a particular
purpose. The remedy for any violation of the implied warranty
shall be limited to repair or replacement of the defective
product pursuant to the terms contained herein.
If you have a question about your Dynarex device or this
warranty, please contact an authorized Dynarex dealer.
LIMITED LIFETIME WARRANTY
WEIGHT CAPACITY: 650 LB.
Bariatric
Commode
Folding
Manufactured for: Dynarex Corporation
10 Glenshaw Street | Orangeburg, NY 10962
USA • www.dynarex.com | Made in China
Reorder No. 10374
SYMBOL GLOSSARY
For an explanation of symbols
used in Dynarex packaging, visit
dynarex.com/symbols.php R220701

ADDITIONAL LEG HEIGHTASSEMBLY INSTRUCTIONS
FIGURE 1
1. Before use, adjust height of each leg to your specific
needs, making sure all legs are at the same height. When
desired height is reached, lock legs into place by aligning
buttons into proper holes (see Figure 1).
2. Be sure legs are locked into place by pushing down on or
by pulling legs.
1. Unfold the sides of the commode frame and stand
upright.
2. Attach front cross brace by depressing brass push pins
and sliding brace into side frame socket. Repeat on the
other side. Be sure brass push pins “snap” through holes.
3. Attach back brace by depressing brass push pins and
sliding back brace into receptacle located on back of
cross brace. Be sure brass push pins “snap” through holes.
4. Lower commode bucket or splash guard into bracket.
5. Attach seat and lid onto back of frame.
• DO NOT use commode without first reading and
understanding this assembly and instruction sheet. If you
can not understand these instructions, contact a
healthcare dealer or technical professional before
attempting to install. Otherwise, injury or damage may
occur.
• Make certain that the height adjusting snap buttons fully
protrude through the respective hole.
• Ensure that all components of the commode are secure
and locked in place.
• Check the rubber tips on the legs for rips, wear or if they
are missing. Immediately replace any or all if any
imperfections exist.
• All four leg extensions with rubber tips MUST be level to
the floor.
• Users with limited physical strength should be supervised
or assisted while using commode.
Splash
Guard
Front Cross
Brace
Side Frame
Socket
Side Frame
Socket
Bucket
Back
Support
Bucket
Frame
Lid
Back
Frame Rail
Seat
Clamps
Seat
Clamps
WARNINGS