dynarex 10460 User manual

LIMITED LIFETIME
WARRANTY
Your Dynarex Product is warrantied to be free of defects
in materials and workmanship for the lifetime of the
product for the original consumer purchaser. This item
was built to exacting standards and carefully inspected
prior to shipment. This Limited Lifetime Warranty is an
expression of our confidence in the materials and
workmanship of our products and our assurance to the
consumer of years of dependable service.
The Warranty shall not apply under the following
conditions:
problems arising from normal wear; problems arising
from failure to adhere to the product instructions;
problems arising from misuse, negligence, accident or
improper operation, maintenance or storage; problems
arising from modifications or unauthorized repairs, parts
or attachments; products where the serial number has
been removed or defaced; Problems with non-durable
components, such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement. Dynarex shall not be liable for any
consequential or incidental damages whatsoever.
Dynarex shall repair or replace defective products at its
option. The foregoing warranty is exclusive and in lieu of
other express warranties, if any, including the implied
warranties of merchantability and fitness of a particular
purpose. The remedy for any violation of the implied
warranty shall be limited to repair or replacement of the
defective product pursuant to the terms contained
herein.
Reorder No. 10460
Manufactured for: Dynarex Corporation
10 Glenshaw Street • Orangeburg, NY 10962
USA • www.dynarex.com
Made in China
Home Bed
Assist Handle
SYMBOL GLOSSARY
For an explanation of symbols
used in Dynarex packaging, visit
dynarex.com/symbols.php R180129
WARNING:
Cancer and Reproductive Harm
www.P65Warnings.ca.gov

• This assist handle is intended for assisting in
and out of bed only. DO NOT use for other purposes.
• DO NOT exert side pressure on the Home Bed
Assist Handle; this could deform or break it.
• DO NOT use the Home Bed Assist Handle as a push
handle for moving the bed; this could deform or
break it.
WARNING
1. Remove mattress from bed.
2. Attach the rail to the base support frame by
depressing the brass lock pins and sliding the rail
into the tubing until the lock pins “snap”
through the positioning holes. (Figure 1).
3. Place assembled base support frame on top of the
bed so that the rail edge is on the outside of the
frame of the bed.
4. Unbuckle the strap and lay flat so that the strap is
exposed on both sides of the bed (Figure 2).
5. Place mattress on bed.
6. Buckle the strap around the box spring or mattress
and adjust by tightening the loose end of the strap
(Figure 3).
INSTRUCTIONS
FIGURE 3
FIGURE 1
Base Support
Frame
Rail
Brass
Lock
Pin
FIGURE 2