dynarex 10323 User manual

Reorder No. 10323
R191129
Shower Chair
without Back
LIMITED LIFETIME
WARRANTY
Your Dynarex product is warrantied to be free of defects
in materials and workmanship for the lifetime of the
product for the original purchaser. This item was built to
exacting standards and carefully inspected prior to
shipment. This Limited Lifetime Warranty is an
expression of our confidence in the materials and
workmanship of our products and our assurance to the
consumer of years of dependable service.
The Warranty shall not apply under the following
conditions: Problems arising from normal wear; Problems
arising from failure to adhere to the product instructions;
Problems arising from misuse, negligence, accident or
improper operation, maintenance or storage; Problems
arising from modifications or unauthorized repairs, parts
or attachments; Products where the serial number has
been removed or defaced; Problems with non-durable
components, such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement. Dynarex shall not be liable for any
consequential or incidental damages whatsoever.
Dynarex shall repair or replace defective products at its
option. The foregoing warranty is exclusive and in lieu of
other express warranties, if any, including the implied
warranties of merchantability and fitness of a particular
purpose. The remedy for any violation of the implied
warranty shall be limited to repair or replacement of the
defective product pursuant to the terms contained herein.
SYMBOL GLOSSARY
For an explanation of symbols
used in Dynarex packaging, visit
dynarex.com/symbols.php
Manufactured for: Dynarex Corporation
10 Glenshaw Street • Orangeburg, NY 10962
USA • www.dynarex.com
Made in China

HEIGHT ADJUSTMENT
1. Inspect all parts for shipping damage before
assembly. If there is shipping damage – DO NOT
USE. Contact dealer/carrier for further instructions.
2. Make certain that the height adjusting brass
push-pins fully protrude through the same respective
hole of each leg extension. This will ensure that the
leg extensions are securely locked in position and an
even height is achieved.
3. Ensure ALL screws, nuts and/or bolts are tightened.
4. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace any
or all if any of these imperfections exist.
5. All four leg extensions with rubber tips MUST touch
the floor simultaneously.
6. When used in a tub, make certain the rubber tips are
not touching the sides of the tub wall.
7. DO NOT stand on chair.
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water.
Wipe bath seat dry after each use.
1. Before use, adjust height of each leg
to your specific needs, making sure
all legs are at the same height. When
desired height is reached, lock legs
into place by aligning buttons into
proper holes, per illustration.
2. Make sure legs are locked into place
by pushing down on or pulling legs.
WARNING
ASSEMBLY INSTRUCTIONS
PRODUCT LIST
Weight Capacity: 400 lb. (180 kg)
4 Legs Chair Base
1. Lay the chair base with the seat surface facing down
and the leg sockets facing up.
2. Depress the brass push-pin and insert the leg into
the socket until the brass push-pin “snaps” through
the hole.
3. Repeat step 2 with the other three legs.
4. Turn chair upright.