Dyson Airblade 9KJ Manual

Dyson backplate
technical specification
Recommended installation heights from floor
Male Y1451 mm
Female Y1416 mm
Wheelchair userY1207 mm
Child 5-8 Y1079 mm
Child 8-11 Y1179 mm
Child 11-14 Y 1256 mm
Dyson backplate dimensions
Height 991 mm Width 575 mm Depth 5 mm
Minimum clearance above machine
210 mm
Rear cable entry point from floor
Male 1293 mm
Female 1258 mm
Wheelchair user1049 mm
Child 5-8 921 mm
Child 8-11 1021 mm
Child 11-14 1098 mm
FLOOR
For further information please contact Dyson
AU: 1800 426 337
[email protected]
www.dyson.com.au
See table for
recommended
mounting heights
Rear cable
entry point
Fixing
locations
(6)
All dimensions
shown in mm
(+/-5 mm)
Not to scale
Front elevation
575 mm
990.7 mm
NZ: 0800 397 667
[email protected]
www.dyson.co.nz

For further information please contact Dyson
Construction
Stainless steel (brushed)
Back plate mounting bracket: Stainless steel – Brushed (304L)
Logistics
Net weight: 6.7 kg /14.7 lbs
Packaged weight: 11.10 kg / 24.47 lbs
Packaged dimensions:
(H) 71 × (W) 664 × (D) 1295 mm
Standard guarantee
5 year guarantee
Installing the Dyson backplate
Where only unsupported plasterboard is available for installation,
a Dyson backplate must be used. Fixing to unsupported plasterboard
(drywall) without the aid of a Dyson backplate will not result in safe
and secure installation for your machine, and may also invalidate
your guarantee.
If the wall you are fixing the machine to has an airgap, the fixings
used must be of a sufficient length to provide a secure installation.
Do not use sealant when attaching the machine to the wall.
The Dyson backplate helps protect the wall from water damage
and can be used to cover holes/marks left from previously installed
products – including the Dyson Airblade dB hand dryer.
Contact the Dyson Helpline for further information.
AU: 1800 426 337
[email protected]
www.dyson.com
NZ: 0800 397 667
[email protected]
www.dyson.co.nz