Eagle Group EL Series User manual

See reverse side for Units with Adjustable H-Frame.
(End)
Assemb y is comp ete.
Step 1 - Attach frame to seat.
• Lay seat upside down so that the gussets face upward.
Note: Take care not to scratch the finish.
• Insert egs into gussets.
• Tighten a screws.
Step 2 - Assemble feet to bottom of legs.
• Use a rubber ma et to insert feet into egs.
Step 3 - Flip the bench
onto its feet.
h-frame
foot
bottom of leg
gussets
seat
gussets
Step 4 - Secure feet to the floor.
Hardware not inc uded.
ASSEMBLY INSTRUCTIONS
EL Series Solid Gowning Benches
with Welded H-Frame
 &5*2&%
"(+&..%2&15*$&04*/,&-3"(+&"-%/&$"1&%*5*2*.-2.'"(+&1.4/7#63)&"(+&1.4/
• 100 Industria Bou evard, C ayton, De aware 19938-8903 U.S.A. • www.eag egrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC) 800/637-5100
• Fax: [phone]
CAUTION
! !
SAVE YOUR BOX AND ALL PACKING MATERIALS.
!!!


set screw
gusset

front-to-back
crossbracing
corner
castings
corner castings
end-to-end
crossbracing
"(+&..%2&15*$&04*/,&-3"(+&"-%/&$"1&%*5*2*.-2.'"(+&1.4/7#63)&"(+&1.4/
• 100 Industria Bou evard, C ayton, De aware 19938-8903 U.S.A. • www.eag egrp.com
• Phone: [phone] • (Foodservice) 800/441-8440 • (MHC) 800/637-5100
• Fax: [phone]
ASSEMBLY INSTRUCTIONS
EL Series Solid Gowning Benches
with Adjustable H-Frame
CAUTION
! !
SAVE YOUR BOX AND ALL PACKING MATERIALS.
!!!
Step 1 - Assemble crossbrace subassembly.
• Assemb e castings to end-to-end and front-to-back crossbracing,
as shown.
• Tighten set screws in the appropriate threaded ho es in castings
(see be ow).
Step 2 - Attach crossbrace subassembly to legs.
• On egs, measure and mark desired height of crossbrace
subassemb y.
• Insert egs.
• Snug the set screws in the appropriate threaded ho e in
each casting (see be ow).
See reverse side for Units with Welded H-Frame.
Step 3 - Assemble feet, legs, and seat.
• Lay seat upside down so that the gussets face upward.
Note: Take care not to scratch the finish.
• Insert egs into gussets.
• Use a rubber ma et to insert feet into egs.
• Tighten a screws.
foot
bottom of leg
set
screw
set
screws
Step 4 - Flip the bench onto its feet.
(End)
Assemb y is comp ete.
Step 5 - Secure feet to the floor.
Hardware not inc uded.
crossbrace
subassembly
set
screw
set screw
gusset