Eaton VoCALL 5 User manual

VoCALL 5
Line Exchange Unit Effective May 2019
Quick Install Guide
Retrot compatibility
If you are replacing an existing EVCS system with this unit then a test
for compatibility must be carried out on the outstations, and any units
which do not function as expected must be replaced with new units.
This advice also applies to all roaming handsets.
Installation
1. Using a Phillips head screwdriver, open the front cover by
removing the 2 screws along the bottom edge of the panel.
Then lift the cover from the bottom edge and push up in order
to disengage the latching clips on the top edge.
2. Before mounting the VoCALL 5 on the wall it is advisable to
remove the cable knockouts. Unused knockouts must be left
unopened to comply with the Low Voltage Directive (LVD),
accidentally knocked out holes should be blanked off.
3. Fix the back box to the wall using the measurements provided
below. Do not drill through the back box to the wall as this will
contaminate the circuitry.
Knockouts
Top: 9 x 20mm
CAUTION
DO NOT power up the unit on batteries as the power
supply has a large reservoir capacitor which may rupture
the battery fuse if the AC is not present when powering
up the system.
1.
2.3.
QUICK INSTALLATION GUIDE 25-16389-B May 2019
Full User Manual and Log Book
available at: www.eaton.com/VoCALL5
4. Wire the mains connection according to the
diagram overleaf.
5. Wire the outstations according to the diagram overleaf.
6. Finally, wire the batteries according to the
diagram overleaf.
ote:N The VoCALL 5 is supplied without batteries which should
be procured separately and be of adequate capacity to
meet local regulations.
Mounting Holes
Mounting Holes
190mm
150mm
237mm

Quick Installation Guide
Effective May 2019
QUICK INSTALLATION GUIDE 25-16389-B May 2019
Eaton
EMEA Headquarters
Route de la Longeraie 7
1110 Morges, Switzerland
Eaton.eu
TEL: [phone]
FAX: [phone]
[email protected]
Firetec[email protected]
© 2019 Eaton
All Rights Reserved
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
www.Eaton.com
Eaton Electrical Systems Ltd.
Wheatley Hall Road
Doncaster
DN2 4NB
TEL: [phone]
FAX: [phone]
P1
MASTER
HANDSET
TO MASTER
HANDSET
OUTSTATION
CONNECTIONS
VOLT-FREE
OUTPUTS
P2
OUTSTATION 1 OUTSTATION 2 OUTSTATION 3 OUTSTATION 4 OUTSTATION 5
FAULT
IN-USE
ENABLE
FLT13 FLT14
P3 P4
3K9 3K9 3K9
P5 P6 P8 P7 P10
Main Distribution Board
230V AC +10%/-15%, 50Hz
>0.75mm2<2.5mm2
VoCALL 5
3A
4.
5.
6.