Edelbrock Nitrous Systems
Super Victor V8 Direct Port with E2 Jet Map
Catalog #71850
OWNER’S MANUAL
©2006 Edelbrock Corporation
Rev. 05/06 - DC/mc
Catalog #71850
Brochure #63-0325
Please read both your DIRECT PORT OWNERS MANUAL and this JET MAP INSERT before installing your Edelbrock Nitrous
System. If you have any questions or comments, please contact our Technical Hotline at: 1-800-416-8628 from 7am - 5pm, Monday
through
Friday
,
P
acific
Standard
T
ime
or
e-mail
us
at
[email protected]. Please
fill
out
and
mail
your
warranty
card.
Qty. Description
❑ 2Victor Pro Nitrous Solenoid
❑ 2Victor Pro Fuel Solenoid
❑ 8Edelbrock E2 Nozzles
❑ 16 3/16” Tubing
❑ 16 Tube Sleeves
❑ 8Blue Tube Nuts
❑ 21/8” Male Pipe Nipples
HP Gain Nitrous Jet Fuel Jet Sugg. Timing Retard
200 HP 24 20 5° - 9° Retard
250 HP 28 24 6° - 10° Retard
300 HP 32 28 7° - 11° Retard
350+ HP 36 32 *See Note
400+ HP 40 36 *See Note
500+ HP 44 40 *See Note
Jet Map
The horsepower gains listed above in the jep map are approximate gains. Depending on engine configuration and tuning, your gains may
be slightly different. The jet map is based on a nitrous system with a flowing fuel pressure of 6½ - 7 PSI. Any variations different than
6½ - 7 PSI will change your jet map and potentially damage your engine. We highly recommend using the Edelbrock Flow Test Tool
(P/N 76506) to set your flowing fuel pressure.
NOTE: When using the high horsepower settings with a direct port system, many variables come into play when setting proper timing
retard, such as timing with your previous horsepower settings, cylinder head configuration, compression ratio, tune-up, etc. We recom-
mend consulting your engine builder to determine proper timing retard before using these settings.
Qty. Description
❑ 8Red Tube Nuts
❑ 16 Compression Fittings
❑ 4Distribution Blocks
❑ 290° Union Fittings
❑ 26AN Nitrous Filter Fitting
❑ 26AN Red Filter Fitting
❑ 56 Various Jets
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in poor
performance and engine or vehicle damage.
BILL OF MATERIALS (Excluding Electrical)
Edelbrock Corporation 2700 California St. Torrance CA 90503
Tech Line: 800-416-8628
