Eden The Huntington Raised Planter Bed User manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service
dept. at 1 800 282 9346, ext #20 (Mon. to Fri.8:00 AM to 4:00 PM EST).
1. Planter Bed Walls (8)
2. Stainless Steel Screws (12)
3. Washers (4)
Tools You Will Need
• Cordless Screwdriver
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 5’x 8’for unobstructed assembling.
• You should not need to use excessive force when assembling component.
The Huntington Raised Planter Bed
Please read through before starting assembly.
ASSEM B LY I N STRUCTI O N S
1
www.edenarbors.com
1
2
Not to Scale
Ver 1/NOV 2011
   
   
   
   
 
3

2
www.edenarbors.com
1
Layout the bottom four walls of the planter bed into place
as shown aside. Walls will simply interlock into place.
Using the screws (4) provided, fasten the walls of planter
bed at all four corners as shown.
Layout and align two walls opposite to each other as shown
and fasten with two screws with washers through the rib of
the wall.
Place the last two walls into place as shown.
Fasten the last two wall into place using the (4) screws
provided.
1
2
3
4
STE P ONE
2
3
4
5
NOTE: The end caps are pre-glued. In the event that any of
the end caps come off, simply use PVC or plumbing glue to
re-attach them to the wall.
5
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: [phone] Toll Free Fax: [phone]