Eden The Windsor Planter Box User manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri.8:00 AM to 4:00 PM EST).
1. Pre-Assembled Side Wall Panels (2)
2. Post Caps (4)
3. Floor Panel (1)
4. Pre-Assembled Front & Back Wall Panels with Posts Connected (2)
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’for unobstructed assembling.
• You should not need to use excessive force when assembling components.
The Windsor Planter Box
Please read through before starting assembly.
AS SE MBLY I NSTRUCTI ONS
1
www.edenarbors.com
STEP ONE
Lay out front wall panel on the work surface.
Insert the side walls into the routed holes on the front wall
panel posts. Push until the locking tabs snap into place.
Connect the Front & Back Wall
to the Side Wall Panels
1
2
1
2
1
4
Ver 1/Aug 2010
11.5 in
15.5 in18.5 in
11.5 in
15.5 in
18.4 in
2
3

STEP T WO
Pressure fit the floor panels into place.
Install the four post caps . Push caps until the locking tabs
snap into place.
The Windsor Planter Box
Insert Floor Panels & Post Caps
5
6
3
1915 Dove St., Port Huron MI USA 48060
Toll Free Phone: [phone] Toll Free Fax: [phone]
www.edenarbors.com
Fit the opposite back wall panel over the side walls. Push until
the locking tabs snap into place.
Reposition the assembled planter box so it stands upright on
the work surface. Ensure at this point that the planter walls are
square to each other. This can be accomplished by making
sure that the corner to opposite corner measurement are equal
both ways.
3
4
2
4
5
6