Elba K Series User manual

Split Type Room Air Conditioner
Use and Care Manual
Identification of parts
Indoor unit
Outdoor unit
Operating and display
Remote controller
Operation instructions
Operation modes
Air flow direction control
Smart mode
Timer mode
Sleep mode
Safety Precautions
Preparation before use
Maintenance
Protection
Troubleshooting
Installation instructions
Installation diagram of air conditioner
Select the installation locations
Indoor unit installation
Outdoor unit installation
Air purging
Notes
2
1
3
3
4
7
8
9
10
11
12
5
13
14
16
17
21
15
21
22
R410A
Refrigerant
R407C
Refrigerant
R410A
Refrigerant
R410A
Refrigerant
R410a
Refrigerant
R22
Refrigerant
Super mode 11
Thank you very much for purchasing ELBA Air Conditioner,
please read this Use and Care Manual carefully before installing
and using this appliance and keep this manual for future reference.
All manuals and user guides at all-guides.com
all-guides.com

Each time after the remote controller replaces batteries or is energized, auto presettingremote controller
heat pump.If the air conditioner you purchased is a Cooling Only one, but you preset the remote controller
as Heat Pump, it doesn't bring any matter.
The appliance is preset as no auto restart function by manufacturer. If you want auto restart function,
let the appliance is energized, hold down the Emergency button (ON/OFF) on the indoor unit for over
5 seconds, auto restart function is set with buzz sound, air conditioner is on standby.
If auto restart has been set, hold down the Emergency button (ON/OFF) on the indoor unit for over 5
seconds, auto restart function is canceled with buzz sound, air conditioner is on standby.
Remote Controller presetting
Before using the air conditioner, be sure to check and preset the following.
Auto Restart Presetting
Hold down any button of remote controller for about 2 seconds, back-light turns on. Release the button,
it lights off automatically 10 seconds later.
Note: Back-light is an optional function.
Back-light function (optional)
Preparation before use
All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com
all-guides.com

MODE
FAN
SWING
SLEEP
SUPER
SMART
TIMER
How to Insert the Batteries
How to Use
Remove the battery cover according to the arrow direction.
Insert new batteries making sure that the (+) and (-) of
battery are matched correctly.
Reattach the cover by sliding it back into position.
Note:
Use 2 LR03 AAA(1.5volt) batteries. Do not use rechargeable batteries.
Replace batteries with new ones of the same type when the display
becomes dim.
Storage and Tips for Using the Remote Controller
The remote controller may be stored mounted on a wall with a holder.
Note: The remote controller holder is an optional part.
To operate the room air conditioner, aim
the remote controller to the signal receptor.
The remote controller will operate the air
conditioner at a distance of up to 7m when
pointing at signal receptor of indoor unit.
Back-light Function (optional)
Remote controller holder
Signal receptor
Remote controller
Please refer to page 1 "Preparation before use" for details.
Remote controller
MODE
FAN
SWING
SLEEP
SUPER
SMART
TIMER
MODE
FAN
SWING
SLEEP
SUPER
SMART
TIMER
All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com
all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com
all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com

All manuals and user guides at all-guides.com