Eleiko Classic SVR User manual

ELEIKO SVR PLATFORM
Classic Line - small
Art.no. 3061381

CAUTION
The equipment must be installed and used in a place whose access and supervision
are specifically controlled by the owner.
Be sure to install the equipment on a stable base and properly level the equipment.
Attach the corners to floor with appropriate fasteners.
SAFETY INSTRUCTIONS
It is the responibility of the purchaser of ELEIKO products to instruct all users and
supervising personnel on proper usage of the equipment.
1. All included warnings (labels) and instructions MUST be read before the use of any
ELEIKO-equipment. Use each equipment as it is intended for.
2. A user MUST get a medical examination and proper instructions before the use of
any ELEIKO-equipment.
3. DO NOT let anyone, under any cuircumstances, use equipment that appears to be
damaged. Do not try to repair any equipment before consulting an ELEIKO technician.
4. DO NOT replace the components of ELEIKO-equipment with other none ELEIKO-
equipment (magnetic safety pin, frames, bars), do not improvise. If there are any
doubts consult an ELEIKO representative prior to any intervention.
5. DO NOT overload the equipment and DO NOT try to exceed personal strength
levels.
6. Children and teenagers must be supervised by a knowledgeable adult.
7. DO NOT remove any safety labels from the ELEIKO-equipment. ELEIKO is not
responsible if a label is removed. Replace damaged labels immediately.
PREVENTITIVE MAINTENANCE & INSPECTIONS
Regularly:
Clean the surfaces on frames and tubes from dust and dirt. Vaccum clean rubber tiles.
Check that all bolts between parts and floor are properly tightened, according to
recommendations.
WARRANTY
All products manufactured by ELEIKO are warranted to the original purchaser to be
free from defects in workmanship and / or materials under normal use or service as
follows:
- 10 years on the frame.
- 1 year on other parts.
Damping areas are expendable wear and tear materials. Indoor use only. Steel plates
only to be dropped from deadlift position. Normal wear and tear do not fall under
warranty.
ADDITIONAL INFORMATION
Discs to be dropped on drop zones only.
READ BEFORE INSTALLATION AND USE

1142
988
1500
1500
1500
1500
Weightlifting training platform. For indoor use only.
Add sufficient
clearance, not less
than 1.5 m (59 in),
on all sides.
Product weight 276 kg / 608 lbs
Dimensions (L x W x H)
2565x2470x100 mm
101x97.2x3.9 in
PRODUCT SPECIFICATION
FOOTPRINT AND FREE AREA

side tube
x2
back tube
x1
x4
bracket
front tube
x1
insert cover
side
x2
insert cover
front
x1 x4
corner
wooden plate
3001400
x1
Foam 666x695x70 mm
x4
Art.no: 2000803
rubber tile
x2
Foam BLACK
666x695x12,7 mm
x4
Foam 500x975x70 mm
x1
Foam 2000x975x70 mm
x1
Screw M10x25
2001124-L25
x16
Plate
3085497
Art.no: 2001344
Wood screw 5x30
x2
x27
CONTENTS

Torx wrench
TX 50
Screw driver
Phillips
REQUIRED TOOLS
Phillips screwdriver

bracket
x4
AW
AU
AV
Loose screws!
corner
x4
Screw M10x25
2001124-L25
x16
1.
x4
ASSEMBLY INSTRUCTIONS

OBS!
front tube
x1
Foam 500x975x70 mm
x1
Foam 2000x975x70 mm
x1
BB
7
3
2.

Foam
666x695x70 mm
x4
Foam BLACK
666x695x12,7 mm
x4
3.

wooden plate
3001400
x1
2000803
rubber tile
x2
Plate
3085497
Art.no: 2001344
Wood screw 5x30
1135
1135
4.
x12x2

side tube
x2
back tube
x1
corner assys
x4
5.

Tighten frame and screws!
6.

wood screw
L=30
x15
insert cover
side
x2
insert cover
front
x1
edge to edge
7.

Ver 2022-01-10

Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden
E-mail: [email protected] | Phone: [phone]
www.eleiko.com
rev. 22-01-10