Elite Screens Evanesce B Series Guide

Evanesce/Evanesce Tension Vertical Limit Switch
Adjustment Instructions
Caution: The screen’s Top Black Masking is already set to its maximum distance. There is NO extra
black top drop in the roller. Attempting to increase the drop will damage the motor and VOID your
warranty with Elite Screens. DO NOT use these instructions to try and get more out of your
standard black masking drop. Please contact Elite Screens before making any adjustments.
A. If you over adjust the rise position the screen will attempt to go further into the case and
cause it jitter and bounce.
B. If you over adjust the drop position the screen will begin to reverse itself back up.
C. eversing the adjustments should bring the screen back to normal operation
1. Allen Wrench
Fig. 1
2. Limit switch adjustment holes
Note: The limit switches can only be viewed when the screen material is completely deployed.
They are located on the right side of the screen when facing the back.
Fig. 2
UP adjustment switch
DOWN adjustment switch
5/32” Allen wrench

Note: When turning the limit switches bear in mind that a full-circle in either direction will create
a one inch adjustment.
3. How to adjust the Retract (rise) position (shown in Fig. 3 to Fig. )
Fig. 3
Fig. 4
Fig. 5
Use the allen-wrench
to turn the UP switch
counter
-
clockwise
If the screen does not retract
completely (as shown in ig.
3), use the following steps.
Press the UP button on the
remote first to retract the
screen as much as possible.
NOTE: Adjustment should be made
while facing the back of the screen

Fig. 6
4. How to adjust the position of the top black masking border
(shown in Fig. 7 to Fig. 9)
Note: All electric screens come with standard top black masking and they cannot be dropped
further. DO NOT use these instructions to try to get more out of your standard black masking
drop.
Fig. 7
One full turn will retract your screen by 1”. In order
to see adjust ent, deploy and retract the screen.
(Warning: If you continue to rotate the switch once
the weight bar fits flush with the casing, the screen
will atte pt to retract further, causing da age to the
unit. DO NOT over turn the switch).
If you need to decrease the amount of
top black masking, refer to the
following steps.
If the screen retracts too far in, press the DOWN
button on the remote to expose the limit switches.
Rotate the UP adjustment switch 1-2 turns
clockwise. Then press the UP button on the
remote to see the new retract position.
Use your remote control to fully lower
the screen.

Fig. 8
Fig. 9
Note: As a rule, Elite Screens does not recommend making any unnecessary
adjustments to the screen, as improper adjustment will damage the unit.
Please contact Technical Support for assistance @ [phone].
Use your allen-wrench to turn the
DOWN switch clockwise.
One full turn equals 1” of decreased drop. In order
to notice the adjust ent, retract and deploy the
screen. Warning: Over adjusting the switch will
da age the otor and void the warranty.
NOTE: Adjustment should be made
while facing the back of the screen