Elite Screens M85XWS1-SRM User manual

Rev. 032410-JA
www.elitescreens.com [e-mail]
Manual SRM Series
Manual Pull-Down Projection Screen
USER’S GUIDE

Rev. 032410-JA
www.elitescreens.com [e-mail]
Pre-installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
INSTALLATION
Flush Wall Mounting
1. Mark the location of where the screen is to be installed for the pre-drilled hole.
2. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave
about 1/8” of an inch from the wall to mount the screen.
3. Mount your screen from the keyhole located on back of screen’s left and right end cap.
Ceiling Mounting (additional hardware required)
Optional installation using a chain to hang the screen from the ceiling.
1. You can also hang the screen on a ceiling by using a chain (not included) and hang it by the two loops
located on each end of the case.
Back of end cap
Front view

Rev. 032410-JA
www.elitescreens.com [e-mail]
SCREEN OPERATION
Note: Always pull the screen down or let it up in a 90-degree vertical angle. Do not allow the screen to touch
the screen case when the screen goes up or comes down to avoid damaging the screen material.
1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull
the screen down by the surface or touch the screen, as it will damage the screen and void the warranty.
Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at
intervals.
2. If you want to the screen to retract back, simply pull the screen down more than 2 inches and retract the
screen back by quickly and smoothly releasing it up gently. The screen is equipped with a SLOW RETRACT
MECHANISM (SRM) which allows the screen to slowly retract without the need to hold on to the handle or
lanyard. Simply release the handle and the screen will retract by itself.
Note: Always release at a 90-degree angle and do not let go until the screen is entirely inside the case
If ever the screen feels stuck, keep in mind that the screen’s mechanism is new and needs to be run up/down
a few times to loosen up. If this happens, carefully with a little force yank the screen straight down to unlock
the screen.

Rev. 032410-JA
www.elitescreens.com [e-mail]
Note: Improperly bringing the screen up/down will damage the screen material or rolling system.
MAINTENANCE
Clean matte white screen material with a soft cloth and mild soap with water.
When not in use, retract screen in its housing to keep the screen material surface clean.
NOTE:
Regardless of mounting method, the screen should be securely supported so that vibration or even abusive
pulling on the viewing surface will not cause the case to work loose or fall. The installer must insure that the
fasteners used are of adequate strength and suitable for the mounting surface chosen.
Manual SRM Series Dimensions Table
Unit: mm
Models
Diagonal
Size/Aspect
Ratio
Case
Length
(A)
Screen
Width
(A1)
View
Width
(A2)
Weight
Bar
Length
(A3)
Bottom
Edge
Distance
(B4)
Screen
Material to
Weight Bar
Height (B3)
View
Height
(B1)
Overall
Height
(B)
End
cap
Height
(B5)
End
cap
Width
(C)
Screen
material
distance
to wall
(C1)
N.W.
(KGS)
M85XWS1-SRM
85" (1:1)
1677
1603
1527
1673
62
1703
1527
1795
92
79.5
20
6.0
M99NWS1-SRM
99" (1:1)
1938
1854
1778
1934
62
1954
1778
2046
92
79.5
20
8.0
M113NWS1-SRM
113" (1:1)
2192
2106
2030
2188
62
2206
2030
2298
92
79.5
20
9.2
M84NWV-SRM
84" (4:3)
1867
1783
1707
1863
62
1456
1280
1548
92
79.5
20
6.2
M100NWV1-SRM
100" (4:3)
2192
2108
2032
2188
62
1700
1524
1792
92
79.5
20
8.0
M120XWV2-SRM
120" (4:3)
2598
2514
2438
2594
62
2005
1829
2097
92
79.5
20
10.4
Unit: inch.
Models
Diagonal
Size/Aspect
Ratio
Case
Length
(A)
Screen
Width
(A1)
View
Width
(A2)
Weight
Bar
Length
(A3)
Bottom
Edge
Distance
(B4)
Screen
Material to
Weight Bar
Height (B3)
View
Height
(B1)
Overall
Height
(B)
End
cap
Height
(B5)
End
cap
Width
(C)
Screen
material
distance
to wall
(C1)
N.W.
(LBS)
M85XWS1-SRM
85" (1:1)
66.0
63.1
60.1
65.9
2.4
67.0
60.1
70.7
3.6
3.1
0.8
13.2
M99NWS1-SRM
99" (1:1)
76.3
73.0
70.0
76.1
2.4
76.9
70.0
80.6
3.6
3.1
0.8
17.6
M113NWS1-SRM
113" (1:1)
86.3
82.9
79.9
86.1
2.4
86.9
79.9
90.5
3.6
3.1
0.8
20.2
M84NWV-SRM
84" (4:3)
73.5
70.2
67.2
73.3
2.4
57.3
50.4
60.9
3.6
3.1
0.8
13.6
M100NWV1-SRM
100" (4:3)
86.3
83.0
80.0
86.1
2.4
66.9
60.0
70.6
3.6
3.1
0.8
17.6
M120XWV2-SRM
120" (4:3)
102.3
99.0
96.0
102.1
2.4
78.9
72.0
82.6
3.6
3.1
0.8
22.9
*Measurement dimensions are intended as a reference only and subject to change without notice. Note: Data Error ±1"

Rev. 032410-JA
www.elitescreens.com [e-mail]

Rev. 032410-JA
www.elitescreens.com [e-mail]
Warranty Policy
Two (2) year warranty parts and labor from defects in workmanship from purchase date as follows.
Three (3) year warranty parts and labor for GEMR
(Government, Education, Military, and Religious purchases)
Each party will be responsible for one way shipping during the warranty period. Elite Screens is not
responsible for applicable International tariffs such as broker fees and customs duties.
A RMA (Return Merchandise Authorization) number must be issued in order to process a replacement or
to authorize a return for warranty repair. Elite Screens will, at its sole option, replace or repair the defective
unit with a replacement *(see exceptions below) after the defective unit is received. Once the product is
received, Elite Screens will send out a replacement *unit to the customer by ground service (subject to
inventory availability). Please do not return any unauthorized items to Elite Screen, as they will be
refused. The RMA number must be included on the outside label of your shipping box. Our warehouse
is not authorized to accept returns without an RMA number on the shipping label. RMA numbers are
valid for 45 days from the date of issue.
Missing Parts must be reported within the 7-day grace period. If reported after 7 days, customer will be
only be responsible for shipping and handling fees. If reported after 30 days of receipt, customer is responsible
for cost of the parts and shipping & handling fees.
*A new or refurbished replacement will be sent out to the customer depending on the type of purchase (new or refurbished) or based
on stock availability.
Please visit link below for full warranty information
North America (USA and Canada) only
For Customer Service and Technical questions, please contact Elite Screens at:
Telephone: [phone]
Fax: [phone]
For Warranty and Service requests please fill out a RMA /Service Form at:
http://www.elitescreens.com/service_form.htm.
Please Visit this link for full Warranty information:
http://www.elitescreens.com/service.htm
PRODUCT REGISTRATION:
WWW.ELITESCREENS.COM/REGISTER.HTM

Rev. 032410-JA
www.elitescreens.com [e-mail]
CONTACT INFO:
US & Canada Tech Support & Warranty Claim
Please contact us at [email protected] or call [phone] #3 Service
Europe Tech Support & Warranty Claim
Please contact us at [email protected] or call [phone]
Asia Tech Support & Warranty Claim
Please contact us at [email protected] or call [phone]
Taiwan Tech Support & Warranty Claim
Please contact us at [email protected] or call [phone]
America:
Elite Screens Inc
16410 Manning Way
Cerritos, CA 90703 USA
Tel: [phone] (877-511-1211)
Fax: [phone]
[email protected]
www.elitescreens.com
Europe:
Elite Screens Europe GmbH
Elite Screens Europe GmbH
Lübecker Straße 1
22087 Hamburg, Germany
Tel: [phone]
Fax: [phone]
[email protected]
www.elitescreens.eu
Elite Screens France
11, Allée William Penn
92150 Suresnes, France
[e-mail]
www.elitescreens.com/fr
India
Elite Screens India
Delhi, Inida
Tel: [phone]
Fax: [phone]
[email protected]
www.elitescreens.com.in
Latin America Contact:
[email protected]
East Asia Contact:
[email protected]
Japan Contact:
[email protected]
Asia:
Elite Screens China Corp.
Longxi Duimianling Industry Zone Longcheng
Longgang District,
ShenZhen GuangDong, China
Tel: [phone]
Fax: [phone]
[email protected]
www.elitescreens.com.cn
Taiwan:
Elite Screens Taiwan Co. Ltd.
No.38, Alley 22, Lane 66, Sec. 5, Nanjing E. Rd.,
Songshan District, Taipei City 105, Taiwan
Tel: [phone]
Fax: [phone]
[email protected]
www.elitscreens.com.tw