EliteProAV T153UWS1-D User manual

Rev. 041217 DR www.eliteproav.com 1
Large Tripod Portable Projection Screen
Tripod Stage Series
USER'S GUIDE
Thank you for choosing the Tripod Stage portable projection screen! Please read through this user guide
before utilizing the screen. Correct usage and maintenance will ensure a long product life.
Care & Use Instructions
◆Dust, dirt and scratches on the projection surface will affect the picture quality, please take note
of the points below to prevent that from occurring:
1. Do not touch the projection surface with your hands
2. Do not write or draw on the projection surface
3. Do not use fingers or sharp objects to point on the projection surface; this will damage the
screen material.
4. Use a soft-damp cloth to clean the projection surface; do not use chemical cleaning agents or
alcohol.
5. Use clean water when dampening the cleaning cloth and do not rub against the material to
clean it.
◆After using the screen, disassemble it and store it in the carrying bag provided.
◆To avoid damage and injury, the screen should only be operated by adults.
Accessories List
A. Curtain B. Carrying Bag

Rev. 041217 DR www.eliteproav.com 2
Tripod Screen Parts Diagram
A. Screen set-up
Follow the steps below and refer to Fig. 1＆2.
1. Place the screen in an upright position (fig.1) with the legs toward the ground.
2. Spread the Tripod Support legs by pushing down on the legs’ junction as shown in fig.2.
3. Rotate the tripod's casing in a 90-degree horizontal position so that the screen’s casing is now
parallel to the ground and the screen’s handle is positioned at the top of the casing.
4. Completely extend the legs as much as possible so they are stable and position them away from
objects that may interfere with their balance.
DO NOT stand the tripod on an uneven platform to avoid injury should the tripod screen collapse.
Screen Material
End Cap
Screen case
Curtain
Top Hook and Screen Handle
Vertical locking sleeve ring
Double lock structure
Carrying handle & Screen height
adjustment double lock/release tab
Tripod Support Legs
Support beam
Vertical
Extension Bar

Rev. 041217 DR www.eliteproav.com 3
B. Preparing the tripod screen for projection:
Follow the steps below and refer to Fig. 3＆4
Note: At least 2 people are needed to set up the screen. Due to the height of the screen when extended,
the use of a stool is recommended to properly hook the handle to the keystone eliminator.
1. While one person holds the casing horizontally leveled, the other person will need to stand on the
stool and pull the screen handle up vertically and hook the screen handle on the Top Hook as
shown in fig. 3 & 4.
2. Twist the Vertical Locking Sleeve Ring counter-clockwise to loosen the Vertical Extension
Bar so that you can adjust the screen to your desired height.
Follow the steps below and refer toFig.5
3. Pull the Screen Height Adjustment Lock/Release tab out (to the left), which is located just
above the Carrying Handle to raise or lower the casing. Once the desired height has been set,
push the tab back into the locked position. Follow the steps below and refer to Fig 6.
Rotate the casing so that it is
parallel to the ground as shown
here.
fig.2
fig.1
3
2
4
1
fig.3
fig.4

Rev. 041217 DR www.eliteproav.com 4
C. Curtain Installation:
Follow the step below and refer to Fig. 7
1. Align the Velcro strip (C) of the curtain to the Velcro strip (D) on the screen’s casing and push
along the length of the strips together so that the curtain sticks to the casing.
C D
D. Screen tear-down:
Follow the steps below and refer to Fig. 8
1. Unlock the Adjustment Handle by pulling the locking tab to the left and slowly slide the
casing down to its furthest point.
2. Hold the Extension Bar and twist the Vertical Locking Sleeve Ring counter-clockwise to
unlock and release the position of the extension bar. Once the extension bar has been brought
all the way down, unhook the screen material from the Top Hook and slowly retract the screen
back into the case. You can then retighten the locking sleeve ring.
fig.7
fig,5
A B
fig,6
A: Counter-clockwise to unlock
B: Clockwise to lock

Rev. 041217 DR www.eliteproav.com 5
Note: It is very important to hold the extension bar first, and then unlock the
sleeve to prevent the extension bar from slamming downwards and damaging the
screen and to help prevent injury.
3. Close the tripod legs by pushing the junction upwards. The casing, extension bar
and tripod legs should all be aligned as shown in fig. 8. Store the tripod in the
provided carrying bag.
Dimensions Table
Models
Numbers
A A2 A3 B B1 B2 B3 B4 B5 B6 C D D1 D2 G
Unit: Inches
T153UWS1-D 108.2 114.3 114.3 108.2 111.8 152.3 40.5 57.9 18.9 130.7 27.6 3.4 114.3 6.5 51.2
T170UWS1-D 120.2 126.3 126.3 120.2 123.8 164.9 41.1 57.9 18.9 142.7 27.6 3.4 126.3 6.5 51.2
Unit: mm
T153UWS1-D 2748 2903 2903 2748 2840 3868 1029 1471 480 3320 700 86 2903 165 1300
T170UWS1-D 3053 3208 3208 3053 3145 4188 1044 1471 480 3625 700 86 3208 165 1300
For a local EliteProAV contact or Technical Support, please visit
www.eliteproav.com
2
1
3
fig.8
Note: Data Error ±1"