Elkay EDFAC11PBC Installation manual

97164C (Rev. D - 1/05)
EDFAC11PBC*A EDFBC12PBC*A
Installation/Care/UseManual
SEMI AND FULLY RECESSED WALL
MOUNT CUSPIDOR ONLY
IMPORTANT
ALLSERVICETOBEPERFORMEDBYANAUTHORIZEDSERVICEPERSON
FIG. 1 FIG. 2
Toassureyouinstallthismodeleasilyandcorrectly,PLEASEREADTHESESIMPLE
INSTRUCTIONSBEFORESTARTINGTHINSTALLATION.CHECKYOURINSTALLA-
TIONFORCOMPLIANCEWITHPLUMBING,ELECTRICALANDOTHERAPPLICABLE
CODES.Afterinstallation,leavetheseinstructionsinsidethefountainforfuturereference.
SEE FIG. 5
27
SEE FIG. 7
26
INSTALLATIONINSTRUCTIONS
1. Remove lower panel from cuspidor by removing the two screws at the lower corners. Rotate the bottom of the panel out and pull
gently downward to remove.
2. Install spreader assembly into cuspidor body and attach straight end of copper tubing as shown in Figure 5. Route the tubing into
the cuspidor compartment and install cuspidor body.
3. Water inlet tube to be 3/8" O.D unplated copper. Waste tailpiece for slip trap is 1-1/4" O.D. Contractor to supply waste trap in
accordance with local codes.
4. Connecting lines to be unplated copper and thoroughly flushed to remove all foreign matter before connection to cuspidor
assembly. The furnished strainer should be installed in the supply line. See Figure 1 DO NOT SOLDER TUBES INSERTED INTO THE
STRAINER AS DAMAGE TO THE O-RINGS MAY RESULT.
5. Connect the cuspidor to supply line with shut off valve and install a 3/8" (10mm) water line between the valve and cuspidor.
EDFAC11PBC EDFBC12PBC
THE GROUNDING OF ELECTRICALEQUIPMENT SUCHAS TELEPHONE, COMPUTERS, ETC.TO WATER LINES
ISACOMMONPROCEDURE.THIS GROUNDING MAYBEINTHE BUILDING OR MAYOCCURAWAYFROMTHE
BUILDING. THIS GROUNDING CAN CAUSE ELECTRICALFEEDBACK INTOAFOUNTAIN, CREATINGAN ELEC-
TROLYSIS WHICH CAUSESAMETALLICTASTE ORANINCREASEINTHE METALCONTENTOFTHEWATER.
THISCONDITION ISAVOIDABLE BYUSING THE PROPER MATERIALSAS INDICATED.ANY DRAIN FITTINGS
PROVIDEDBYTHEINSTALLER SHOULD BE MADE OF PLASTICTOELECTRICALLYISOLATETHEFOUNTAIN
FROMTHE BUILDING PLUMBING SYSTEM.
IMPORTANT! INSTALLER PLEASE NOTE.
Installer
NOTE: WATER FLOW
DIRECTION
BUILDING WATER
INLET
SERVICE STOP
(NOT FURNISHED)
1/4" O.D. TUBE
WATER INLET
TO COOLER
3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY

97164C (Rev. D - 1/05)
EDFAC11PBC*A EDFBC12PBC*A
FIG. 3
EDFAC11PBC ROUGH-IN
PAGE 2
LEGEND: A= WATER INLET LOCATION. 3/8" O.D. UNPLATED COPPER TUBE CONNECT. B = CUSPIDOR WASTE OUTLET LOCATION. 1-1/4" O.D. DRAIN (TRAP NOT FURNISHED) C = WALL HANGER - 12" (305mm) x 1" (25mm) FURNISHED LOOSE.
D = MOUNTING HOLES FOR 1/4" DIA. (6mm) SCREWS.
FINISHEDFLOOR LINE

97164C (Rev. D - 1/05)
EDFAC11PBC*A EDFBC12PBC*A
PAGE 3
FIG. 4
EDFBC12PBC ROUGH-IN
LEGEND: A= WATER INLET LOCATION. 3/8" O.D. TUBE CONNECT. B = CUSPIDOR WASTE OUTLET LOCATION. 1-1/4" O.D. DRAIN (TRAP NOT FURNISHED) C = WALL HANGER - 12" (305mm) x 1" (25mm) FURNISHED LOOSE.
D = MOUNTING HOLES FOR 1/4" DIA. (6mm) SCREWS.
FINISHEDFLOOR LINE

97164C (Rev. D - 1/05)
EDFAC11PBC*A EDFBC12PBC*A
PAGE 4
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL1.800.323.0620
ELKAYMANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL60523 • 630.574.8484
DESCRIPTION
15005C
21705C
21708C
22911C
22912C
40575C
40038C
40045C
40572C
40573C
40206000
40624C
50074C
50198C
50986C
61314C
70002C
70018C
70278C
75555C
70378C
55996C
70920C
70971C
70977C
55001100
55001091
28579C
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
NS
PARTNO. RETAININGNUT
CLIP-PUSHROD
PUSH BAR ASSY
LEVER-PUSH
BRACKET-PUSHBARMTG
STRAINER&FERRULE ASSY
STRAINER-TAILPIPE
HEXNUT
TAILPIPE
FERRULE
RETAINER
HEAD-SPREADER
GASKET-TAILPIPE
BUSHING-NYLON
HOLDER-REGULATOR
REGULATOR
SCREW- #10 X .50 HHSM
NUT- 1/4-20 HEX
ROD-SUPPORT
CLIP
ROD-PUSH
STRAINER
ROD-PIVOT
ELBOW
NUT-LOCK1/2 CONDUIT
CUSPIDOR(EDFAC11PBC)
CUSPIDOR(EDFBC12PBC)
WALLHANGERBRACKET
ITEMNO. PARTSLIST
FIG. 7
24
25
12
19
11
23
18
5
20
8
16
17
18
14 11
2
21
14
17
3
14
15
22
4
14
FIG. 5 FIG. 6
26
1
1
13
6, 7, 10
9