Endless Summer ENDLESS SUMMER WK-INS-100 E User manual

®
Outdoor Patio Heater
Wheel Assembly Kit
WK-INS-100 E
1. Wheel Assembly . . . . . . . . . . . . . . . . . . . . . 56-01-378
Component Hardware
A Wheel Bolt 2 pcs
5/16” - 18 x 15 Stainless Steel Hex Head Bolt
B Wheel Nut 2 pcs
5/16” - 18 Stainless Steel Hex Nut
C Wheel Washer 2 pcs
8 mm Stainless Steel Washer
Step
1
Attach wheel assembly during heater assembly
Note: Attach wheel assembly to base prior to attaching the weight plate.
A. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
B. Continue heater assembly in Owner’s Manual.
Attach wheel assembly after heater is assembled
A. Lay heater on its side. Be careful not to damage your dome. Support the post on a box or other sturdy item.
B. Remove weight plate, if needed.
C. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
D. Reassemble weight plate, if removed.
E. Stand heater upright.
A
B
C
Manufactured in China for:
Blue Rhino Global Sourcing, LLC
104 Cambridge Plaza Drive, Winston-Salem, NC 27104 USA
1.800.762.1142, www.bluerhino.com
© 2005 Blue Rhino Global Sourcing, LLC. All Rights Reserved
Endless Summer® is a Registered Trademark of Blue Rhino Global Sourcing, LLC. All Rights Reserved