Endura Trilennium 3020 Guide

Trilennium® 3020 Multi-Point
Locking System
Replacement Instructions
• Screwdriver or Drill
TOOLS REQUIRED:
• Trilennium®3020 Multi-Point Lock
• Mounting Screws
KIT INCLUDES:
STEP 1: REMOVE THE HANDSET FROM THE INACTIVE DOOR PANEL
Remove the screws securing the handset from the interior
escutcheon. Make sure to hold the exterior escutcheon as the screws
are being removed to prevent damage. Set aside the handset along
with all of the internal components.
STEP 2: REMOVE THE DUMMY ASTRAGAL FROM THE INACTIVE DOOR PANEL
b. Remove the dummy astragal from the door
panel and set it aside for reinstallation later.
a. Remove the strike plate assemblies and set aside for
reinstallation later.
Note carefully where each screw goes, particularly
the two machine screws holding the center strikes.
They will be shorter than the rest.
!
Exterior
Escutcheon
Interior
Escutcheon
!

STEP 3: REPLACE THE OLD LOCK WITH THE NEW LOCK
a. Remove the screws securing the lock to the door
panel.Remove the lock from the door panel and discard.
b. Insert the new 3020 lock into the pocket in the door
from which the old lock was removed. Secure the lock in
place with the screws provided.
STEP 4: REINSTALL THE DUMMY ASTRAGAL AND HANDSET
a. Align the dummy astragal over the
lock and reinstall.
b. Reinstall the strike plate
assemblies into the routed pockets
on the astragal.
c. Reinstall the handset onto the
inactive door panel ensuring all
internal components are in place.
SKU: BD-INST-TRIL3020
Revised: 06.07.2017
8817 West Market Street, Colfax, NC 27235
800.334.2006 Fax: [phone]
www.enduraproducts.com
Ensure the machine screws
removed from the strike
plates are returned to the
original location.
!
!